An Effective Charge Neutralization Enabled by Graphene Overlayer in Ambient Pressure XPS Measurements of Insulators

Abstract

Ambient pressure XPS is a powerful technique capable of performing measurements with samples kept at mbar pressure. The filled gas, also X‐ray ionized, provides electrons to neutralize positive charges built up on insulating samples. However, this convenient neutralization scheme does not solve the charging problem completely. In this study, the effectiveness of how the electrons generated from conducting mechanical parts mounted in the immediate front of insulating samples neutralize positive charges on the samples during XPS measurements is tested. The mechanical parts range from fine gold mesh, holey carbon film to graphene monolayer, and measured insulating samples are polished sapphire and rough pellets of CaCO3 powder. All these mechanical add‐ons reduce the charging to different degrees at the expense of sample signal. Amazingly, the graphene monolayer is found to effect perfect charge neutralization for both smooth sapphire and rough CaCO3 pellet, evidenced by realistic spectral profile and binding energy values. The finding that an untreated CaCO3 pellet is often terminated with Ca(OH)(HCO3) is consistent with earlier reports. It is speculated that a likely conformal covering with graphene on the sample with rough morphology holds the key to its superb performance in charge compensation.

X-ray-induced piezoresponse during X-ray photon correlation spectroscopy of PbMg1/3Nb2/3O3

“…The variation in the correlation function is clearly reduced at lower incident beam intensities. A standard method to reduce surface charging is to coat the surface with a thin conductive layer such as carbon (Suzuki et al, 2020;Yang et al, 2021). To experimentally test whether static charging of the sample surface by the X-ray beam could play a role, we prepared a different sample having a thin ($ 1 nm) carbon film evaporated onto the surface, spanning the two electrodes, as shown in Fig.…”

Revealing the Surface Species Evolution on Low‐loading Platinum in an Electrochemical Redox Reaction by Operando Ambient‐Pressure X‐ray Photoelectron Spectroscopy

“…The membrane with deposited Pt catalyst was placed beneath the graphene in the water, and the liquid surface was then lowered such that the membrane's surface became covered by the graphene. [21] The graphene-capped sample was held in a dry box for the removal of moisture prior to the experiments.…”