An In-Depth Cross-Layer Experimental Study of Transport Protocols over Circuits

McGinley, Mark; Bhuiyan, Helali; Li, Tao; Veeraraghavan, Malathi

doi:10.1109/icccn.2010.5560071

Cited by 4 publications

(2 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Conclusions: Our experiment proved that in the TBF queueing discipline, the initial condition is a full token bucket. Therefore, users should be aware that when using UDP to transfer data, or when using TCP with a large initial congestion window (cwnd), as with CTCP [33], a packet burst whose size is determined by the burst parameter of TBF will be sent back-to-back at the NIC rate.…”

Section: Methodsmentioning

confidence: 99%

See 1 more Smart Citation

A Cross Layer Design for Large Data Transfers

Alali¹

View full text Add to dashboard Cite

Software Defined Network (SDN) technologies have enabled the introduction of new services such as dynamic Layer-1 (L1) circuits and Layer-2 (L2) virtual circuits (VCs). Our objective is to fully realize high-rate circuits/VCs with almost zero packet loss for large dataset transfers. A multidomain SDN dynamic Layer-2 (L2) VC was used to conduct experiments to achieve this objective.The results showed that a combination of (i) Circuit TCP (CTCP), in which the sending rate is held fixed, and (ii) Token Bucket Filter (TBF) rate shaper at the sending host, is best to achieve, high-throughput transfers. However, packet losses were still observed on these L2 VCs. Therefore, a new study was presented using more controlled environments.A new experimental study was undertaken in a single-rack testbed in which packet losses and delays could be deliberately controlled. Three cases were emulated: (i) single circuit/rateguaranteed VC for a single large transfer from a server, (ii) multiple simultaneous large transfers from a server, and (iii) semi-rate-guaranteed VC. CTCP and the TBF queueing discipline of the Linux traffic control (tc) utility are recommended for the first case, and parameter selection methods are provided. For the second case, the tc Hierarchical Token Bucket (HTB) discipline is required to support multiple transfers, each on a distinct VC with its own rate and Round-Trip Time (RTT). Our experiments showed that dynamic additions and deletions of classes are possible without impact on ongoing large-transfer flows. For the third case, CTCP is recommended if the throughput of the large transfer is of primary concern, while HTCP is recommended if higher consideration should be given to the other flows.The thesis also provides insight and lessons learned about the to Linux TCP/IP stack. Three layers were considered: (i) Application layer, (ii) Transport layer, and (iii) Data-link layer. New iv v findings, which are beneficial to networking researchers are presented. We also provide insights into how to monitor flows using tools such as tcpdump, tshark, and tcptrace. AcknowledgmentsI would like to take this opportunity to thank many people without whom this thesis would have not

show abstract

Section: Methodsmentioning

confidence: 99%

“…In prior work [33], our research group developed a transport-layer protocol designed specifically for use on circuits/VCs. The transport-layer protocol is named Circuit-TCP (CTCP) because it is simply TCP without congestion control.…”

Section: Transport-layer Protocolsmentioning

confidence: 99%