An Investigation into Microstructures and Mechanical Properties of 1060 Pure Aluminum during Submerged Friction Stir Processing at a High Rotating Speed

Abstract

In this work, 1060 pure aluminum was subjected to high rotating speed submerged friction stir processing (HRS-SFSP). The heat cycle curve of the processing area was measured by K-type thermocouple and temperature recorder. The microstructure, grain size, texture, and tensile fracture of the processing area were analyzed by electron backscattered diffraction and scanning electron microscopy. The results show that the HRS-SFSP caused severe plastic deformation of 1060 aluminum and produced fine recrystallized grains. The minimum average grain size was 0.686 μm at the 2-pass. In addition, the dislocation density in the stirred region was greatly reduced and the high angle grain boundaries (HAGBs) were dominant. The texture strength of pure aluminum increased with the increase in processing passes. The maximum hardness of 66.3 HV and ultimate tensile strength of 95.2 MPa were obtained at 1-pass, which were 86% and 33.9% higher than those of the base material, respectively. The hardness and strength of the stirring zone (SZ) decreased with the increase in the number of processing passes. Therefore, HRS-SFSP pure aluminum can obtain high strength and hardness while maintaining good plasticity.

Numerical Analysis of the Effect of Coefficient of Friction on the Formability Behaviour of Aluminium AA1060 in the Stretch-Forming Process

“…It is characterised by high corrosion resistance and is suitable for heat and electrical conductivity, so it is used in the electrical and chemical industries. It has low mechanical strength (low K and n-value) compared to other Aluminium alloys (1) consequently, the low Formability of this sheet material is the major challenge for forming Aluminium AA1060. The deformation in the Sheet Metal Forming process can be classified into drawing and bending.…”

Inhomogeneous Microstructure Evolution of 6061 Aluminum Alloyat High Rotating Speed Submerged Friction Stir Processing

“…It consists of a shaft shoulder tool with a pin tool, which rotates and moves forward at the same time. The friction between the shaft shoulder and the sheet is used to soften the metal in the processing zone, and the microstructure of the plate changes significantly under the shear action of the pin tool, and then changes the technology of various properties of materials [ 9 , 10 , 11 , 12 ]. There is no doubt that FSW or FSP, as an advanced solid-state connection and processing technology, has a good application prospect.…”