An Investigation on Bending Capacity of Support Stiffness Wall-Slab Structural System by Using Single Layer and Double Layer of Rebar for Residential Project

Abstract

Wall-slab structural system is a system suitable for use in the field of high-rise building where the main load resisting system is in the form rigidly connected wall slab member. Concrete vertical walls may serve both architecturally partitions and structurally to carry gravity and lateral loading. Moment transfer of joint is an important aspect for proper structurally functioning of wall-slab system. Hence, the main aim of this study is to investigate experimentally the effect of reinforcement details in the wall on bending capacity for support stiffness in wall-slab system for residential project in Malaysia. A total of six wall specimens were tested based on the specification given by the project contractor. Three of this specimens consisted single layer of rebar while another three specimen consisted of double layer of rebar. The size of the wall-slab’s specimens is 1000mm in length (L), 1080mm in width (W), 1000mm in height (H) and 80mm in thickness (T). The average concrete strength was 23.49MPa with Grade 30N/mm2 and the average yield strength of R5 bar was 817MPa. The predicted bending capacity at failure is in the range from 5.36kNm to 7.12kNm, depending on actual concrete cover. The bending capacity at failure for single layered of rebar in wall for specimen 1, 2 and 3 were found to be 3.59kNm, 3.81kNm and 3.15kNm, respectively. The bending capacity at failure for double layered of rebar in wall for specimen 1, 2 and 3 were 5.50kNm, 6.31kNm and 7.00kNm, respectively. The average percentage difference in stiffness of double layered of rebar in wall based on load-deflection curve obtained is in the range from 116.17% to 289.88% higher than single layered of rebar in wall. Based on the experimental results, specimens consisted of double layered of rebar in wall is found to provide higher bending capacity to the joint of wall-slab structural system in the range from 56.25% to 98.86% compared with single layered of rebar in wall.

Seismic performance on stiffness and hysteresis loop of interior wall-slab joint for tunnel form building designs to British standard

“…In [10] shows a computational analysis of seismic damage in shear wall-slab junction of an RC wall-frame building. Bending capacity for support stiffness in wall-slab system have been studied by [11][12][13][14][15]. …”