Analysis and Assessment of Use of Voltage and Current Inverters Applied to the Ozone Generation in High Frequency

Aquí-Tapia, Juan Antonio; Ponce-Silva, Mario; Rodríguez-Benítez, Óscar Miguel; Saavedra-Benítez, Y.I.

doi:10.1109/tps.2021.3065917

Cited by 2 publications

(4 citation statements)

References 36 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the existing literature, different designs considered modeling the ozone chamber using different methods, depending on the input of the ozone chamber, which could be air or oxygen. Aqui-Tapia et al [7] modeled the ozone chamber as a series RC with the input being either air or oxygen. The capacitor and resistor values were 2.71 nF and 19.16 kΩ, respectively.…”

Section: Ozone Chamber Modelmentioning

confidence: 99%

“…Aqui-Tapia et al [7] analyzed the use of inverters for ozone generation. The paper compared two main topologies: a voltage source full-bridge inverter (Figure 2) and a current source full-bridge inverter.…”

Section: Sinusoidal Power Supplies For Ozone Generationmentioning

confidence: 99%

“…Furthermore, in this paper, two different power supply topologies are analyzed and compared for their feasibility and voltage gain, which are the inverter followed by a parallel LC filter [7], and an LCL filter. The following subsections derive the mathematical models and analyses of the different sinusoidal power supply topologies, as shown in Figure 6.…”

Section: Power Supply Topologiesmentioning

confidence: 99%

“…Figure 6a provides the schematic diagram for the sinusoidal power supply based on the inverter with a parallel LC filter [7]. The derivation for the transfer function and the gain of the parallel LC filter is shown below.…”

Section: Inverter With Parallel Lc Filtermentioning

confidence: 99%

See 3 more Smart Citations

Performance Evaluation of Sinusoidal Power Supplies for Ozone Generation in Water Purification Applications

Shibl,

Shouman,

Mahmoud

et al. 2024

Sensors

View full text Add to dashboard Cite

Ozone generation is a water disinfection method, superior to chlorine in terms of fewer byproducts and no residual taste. However, its high production cost limits its widespread adoption. This paper designs an ozone generation sinusoidal power supply for water treatment. Ozone generation requires a high-frequency and high-voltage power supply to produce ozone from oxygen molecules. The study evaluates two power supply topologies, one with a parallel LC filter and the other with an LCL filter, assessing their feasibility, effectiveness, and reliability. Theoretically, the LCL filter achieves higher gains than the parallel LC filter. The larger inductance in the parallel LC filter reduces gain, while the larger inductance in the LCL filter increases gain. Simulation and practical results validate these findings, achieving gains of 40 for the parallel LC filter and 150 for the LCL filter.

show abstract

Section: Ozone Chamber Modelmentioning

confidence: 99%

Section: Sinusoidal Power Supplies For Ozone Generationmentioning

confidence: 99%

Section: Power Supply Topologiesmentioning

confidence: 99%

Section: Inverter With Parallel Lc Filtermentioning

confidence: 99%

See 2 more Smart Citations