Analysis of Electromagnetic Transient Characteristics on the Winding of UHVDC Converter Transformers Based on an Improved Broadband Model

He, Shuang; Li, Jiangtao; Wang, Yifeng

doi:10.1109/tmag.2022.3167318

Cited by 3 publications

(1 citation statement)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The transmission characteristics of instrument transformers at varied frequencies significantly impact the secondary side waveform. Conventional VTs and CVTs have upper bandwidth limits near 10 kHz, with severe traveling wave distortion on the secondary side [33,34]. The electric equipment manufacturer developed a voltage measuring device that can be integrated into circuit breakers consisting only of a capacitive divider [35].…”

Section: Voltage Measuring Devicesmentioning

confidence: 99%

A high speed and sensitive protection for distribution network with DGs using ferrite rings as line boundary

Chang,

Yan,

Zhang

et al. 2024

IET Generation Trans & Dist

View full text Add to dashboard Cite

There exist problems of hard coordination and threshold setting as well as low sensitivity in overcurrent relay due to the bidirectional and small fault current when distributed generators are integrated into the distribution network. This paper introduces ferrite rings (FRs) to act as boundaries of distribution feeders, and a peak time of voltage traveling wave‐based protection is proposed. The characteristics of FRs are analyzed and their feasibility as line boundary is validated. The fault characteristics of internal and external faults are analyzed when FRs are installed at both ends of the protected feeder. The results show that the peak time of the voltage travelling wave of the internal fault is far smaller than that of the external faults. According to the difference, the fault detection method and the protection scheme are proposed. Simulations in PSCAD and experiment validate that the proposed protection principle can reliably distinguish between internal and external faults. Besides, the proposed protection scheme has higher sensitivity compared to ROCOV‐based protection.

show abstract

Section: Voltage Measuring Devicesmentioning

confidence: 99%