Analysis of Laser Cutting Process for Different Diagonal Material Shapes

Abstract

In this study, the laser cutting characteristics were analyzed according to the shape of the back side of the specimen, and the laser cutting characteristics were compared according to the thickness of the edge (10 mm, 20 mm, and 30 mm). A Yb-YAG laser was used in this study, and the cutting target was STS304 with a thickness of 50 mm, and the cutting process was analyzed using a high-speed camera. In the experiment, it was found through image analysis that the cutting performance was excellent at 30 mm thickness of the edge. In order to analyze this reason, a thermal conduction analysis (numerical simulation) was performed, and it was confirmed that the thicker thickness of the edge caused a preheating effect during laser cutting due to a large amount of heat accumulation. This effect can be used as a reference for the initial processing state while cutting thick metals as it is a characteristic that has not been revealed before.

Capability Enhancing of CO2 Laser Cutting for PMMA Sheet Using Statistical Modeling and Optimization

“…As a result, the material is melted, burned, vaporized, impressed using a jet of gas, or otherwise removed, leaving behind a superior surface polish. Laser cutting can cut through materials up to 20 mm thick, depending on the laser's power [7][8][9].…”