Analysis of methods of forming diesel and bioethanol fuel mixture

Khakimov, Bakhodir; Rajabov, N Q; Sharipov, Zayniddin; Kalandarova, S T; G’aniboyeva, E M; Kulmamatov, O A

doi:10.1088/1755-1315/868/1/012022

Cited by 5 publications

(6 citation statements)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Currently, research and development activities aimed at the development of new scientific and technical bases of resource-saving technologies and mixed fuel preparation devices, which implement the use of alternative fuels to save traditional fuels, are being carried out. On the basis of theoretical and experimental researches, heating up a quantitative mixture of bioethanol to diesel fuel, the transfer device (temperature stimulator) to the engine supply system was adapted to be installed on TTZ-80-10, MTZ-80X tractors based on the initial requirements and technical conditions, and for use in the educational workshop of TIIAME, its experience and test samples were prepared and field tests were conducted in the farms of "Tashkent Agroservis MTP" LLC, Upper Chirchik, Saykhunabad district of Syrdarya region and Kamashi district of Kashkadarya region [4,5,6].…”

Section: Methodsmentioning

confidence: 99%

“…Analysis of the presented graph shows that the rate of passage of the mixture passing through the holes of the plate installed in the heat pipe depends on the number of holes. Based on the abovementioned expressions, conducted studies and information provided in the literature, table 1 presents the parameters of the device elements for preparing bioethanol mixed fuel [5,6]. On the basis of the results of the research, a graph of the change in the pressure of the mixture of diesel fuel and bioethanol obtained through the perforated pipe with filter pampers was constructed.…”

Section: 𝑚 = 𝜌 ⋅ 𝑉mentioning

confidence: 99%

See 1 more Smart Citation

Tests on the tractor installed experimental device for heating the mixture of bioethanol in diesel fuel

Khakimov,

Sharipov,

Alikulov

et al. 2023

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

Research and development activities aimed at the development of new scientific and technical bases of resource-saving technologies and mixed fuel preparation devices, which implement the use of alternative fuels to save traditional fuels, are being carried out. On the basis of theoretical and experimental studies, the initial requirements and technical conditions of the device for heating the bioethanol mixture to the diesel fuel and the engine supply system was tested. The fuel mixture prepared by heating the recommended diesel fuel and bioethanol proportioned mixture was tested on the TTZ 80.10 tractor. The tests showed that the specified injection angle of the UTN-5 fuel pump was advanced by 2 degrees, and the injector needle pressure was determined to be 1.4-1.6 MPa.

show abstract

Section: Methodsmentioning

confidence: 99%

Section: 𝑚 = 𝜌 ⋅ 𝑉mentioning

confidence: 99%

Tests on the tractor installed experimental device for heating the mixture of bioethanol in diesel fuel

Khakimov,

Sharipov,

Alikulov

et al. 2023

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

show abstract

“…They get into the gap between the rubbing parts and cause rapid wear of the surfaces. Therefore, it is recommended to use the method of gentle cleaning of the oil in full flow mode with frequent replacement of filter elements [9,10].…”

Section: Methodsmentioning

confidence: 99%

Effective use of motor oil resources of the tractor of the company “Claas” in the conditions of Uzbekistan

Ganiboyeva

Norov

Suyunov

et al. 2022

IOP Conf. Ser.: Earth Environ. Sci.

View full text Add to dashboard Cite

Annotation The article describes in detail the reliable operation of modern high-performance and complex “CLAAS” techniques, the correct selection of lubricants and compliance with the optimal operating procedure, as well as the results of the analysis of friction elements of motor oils. It is necessary to compare the quality indicators determined on the basis of research and the concentration of friction elements in the oil with standard values. In order to determine the recommended engine oil change intervals in the engines of CLAAS tractors, it is necessary to determine their quality indicators and the concentration of friction elements in the oil. In order to maintain the performance of the oil, it is recommended to add additives during operation. Study of wear conditions of oils used in internal combustion engines. Determination and justification of the limit working life of oils used in internal combustion engines. Study and justification of properties of interchangeable oils used in internal combustion engines. It is necessary to develop scientific justification and recommendations for increasing the service life of the oils used in internal combustion engines.

show abstract

“…This phenomenon sharply reduces the quality of seed placement with soil and leads to a deterioration in the necessary conditions (temperature, water-air conditions) for plant growth [9][10][11][12][13][14][15].…”

Section: Introductionmentioning

confidence: 99%

Theoretical substantiation of the form of working separator bodies at pre-sowing stone soil treatments

et al. 2023

View full text Add to dashboard Cite

The article discusses a method for planting seeds in stony soil and a device for its implementation. It has been established that the quality of seed placement in the soil significantly depends on the quality of formation of the earthy soil layer at a depth of seed placement. A method is proposed for planting seeds in stony soil, which includes cutting off the upper layer of stony soil with its simultaneous separation, formation of stony and fine-grained layers from it and laying them alternately on top of each other, forming grooves, laying seeds on its bottom and falling asleep seeds with soil. In contrast, the depth of cut of the upper layer of stony soil is taken equal to the sum of the depth of seeding and the maximum size of stones. To implement the method, a proposed device includes a frame, a ploughshare mounted on it, and a separating grid made of several parallel wire elements, sowing machines, disc coulters, and fenders. The economic efficiency of the proposed technical solution is associated with maintaining the period of the emergence of seedlings and, accordingly, increasing the yield of crops, as well as increasing the productivity of sowing machines.

show abstract

Analysis of methods of forming diesel and bioethanol fuel mixture

Cited by 5 publications

References 0 publications

Tests on the tractor installed experimental device for heating the mixture of bioethanol in diesel fuel

Tests on the tractor installed experimental device for heating the mixture of bioethanol in diesel fuel

Effective use of motor oil resources of the tractor of the company “Claas” in the conditions of Uzbekistan

Theoretical substantiation of the form of working separator bodies at pre-sowing stone soil treatments

Contact Info

Product

Resources

About