Analysis of Population Pressure and Environmental Carrying Capacity on Agricultural Land in Lampung Province

Abstract

Population growth is a problem that can lead to the conservation of agricultural land. This can result in increasing population pressure on agricultural land. The purpose of this study was to determine the condition of population pressure and environmental carrying capacity (ECC) on agricultural land in Lampung Province 2020. This province was chosen because it has the highest urbanization rate on Sumatera Island at 6.5% in 2015. Lampung also has the highest population density on Sumatera Island at 244 people/km in 2019. Data were collected through secondary sources and calculated using environmental carrying capacity (ECC) calculations. Then the resulting data were analyzed using quantitative descriptive methods. The results showed that the area with the highest agricultural land area was Lampung Barat at 14685.71 Ha and the lowest area was Metro at 2895.28 Ha. The minimum land area for decent living or the widest z value is in Metro Regency with a value of 0.448 and the narrowest is 0.178 Lampung Barat Regency. The results of the population pressure (Pp) model I show that the areas of Lampung Barat, Mesuji, Tulang Bawang Barat, and the Pesisir Barat are suitable for agriculture. Model II has two additional regions, namely Tulang Bawang and Way Kanan. However, on the assumption of model III with sharecropping of sharecroppers and the non-agricultural sector, the area that is friendly to the agricultural sector is only in Bandar Lampung and Pesisir Barat. The results of the calculation show that the area with the highest environmental carrying capacity (ECC) is the Pesisir Barat and the lowest is the Lampung Tengah region.

Analysis of Potential Development of Goat Farming at Bantul Regency, in Special Region of Yogyakarta, Indonesia

“…Based on the results of the analysis, the average population pressure value in Bantul Regency is 0.46, it means Bantul has not been experienced population pressure. Rohmah et al, (2022) states that if the population pressure value or PP <1 means that the area has not been experienced population pressure. Putri et al (2019) states that population pressure is a symptom of overpopulation in an area, considering the availability of resources for the needs of the population, in accordance with the desired standard of living in the area concerned.…”