Analysis of Shear Stress and Rutting Performance of Semirigid Base Asphalt Pavement on Steep Longitudinal Slope

Abstract

Rutting is the most common distress of the asphalt pavement with a semirigid base, mainly when located on a steep longitudinal slope. Previous studies have shown that shear stress is the leading cause of rutting. Therefore, it is essential to analyze the distribution characteristics of shear stress to evaluate pavement rutting performance. Firstly, the truck speed was measured at different locations on the steep longitudinal slope section. Then, the calculation method of shear stress was improved based on the method of “systematic clustering.” The distribution characteristics of shear stress were studied under the different gradients, slope lengths, horizontal forces, and interlayer bond conditions. Finally, the rutting prediction model was used to evaluate the rutting performance of the steep longitudinal slope section. The results show two critical parameters of a steep longitudinal slope: gradient and slope length can be quantified by establishing the relationship between truck speed and those parameters. The improved shear stress calculation method can correspond well with the layer where maximum rutting occurs. Gradients and slope lengths have little effect on shear stresses, while horizontal forces and interlayer bond conditions significantly change the shear stress distribution characteristics within the pavement. For the steep longitudinal slope sections, the rutting prediction model should consider the truck speed separately. With increasing gradient and slope length, the rutting increases the fastest in the middle layer. For sections with horizontal forces and poor interlayer bonding, the layers with the highest rutting accumulation are the upper layer and the lower layer, respectively.

Estimation of Asphalt Mixture Fatigue Behaviour Using the Two-Point Bending Test

“…The asphalt mixture being a viscoelastic and anisotropic material, its mechanical characteristics change depending on certain factors: temperature, loading frequency and loading method Sun, 2019, Cheng, Wang andLiu, 2021c), Guo et al, 2021, Hu et al, 2022, Liu et al, 2022a, Xing et al, 2022, Yang et al, 2020, Zhang et al 2021. Fatigue resistance is influenced by different load variations (Mateos et al 2018, Xiao et al 2022.…”

Viscoelastic Dynamic Response of Asphalt Pavement in Long Slope Sections

“…In these sections, the interface between layers of asphalt pavement is usually not very well, and the pavement surface is prone to cause diseases such as slippage and congestion, which significantly impairs the service life and driving comfort of the road. Under these conditions, the horizontal load caused by the vehicle starting and braking can't be ignored [1]. To better understand the mechanical behavior of the asphalt pavement in these sections, we focus on the performance of the typical asphalt pavement section, the long slope section.…”