Application of Kolmogorov–Sinai’s Metric Entropy for the Analysis of Mechanical Properties in the Bending Test of Epoxy–Rubber–Glass Composites

Abstract

The article presents an analysis of the results obtained during the three-point bending test for seven variants of epoxy rubber–glass composites manufactured according to innovative technology. Different contents of rubber recyclate (3, 5, and 7%) and different methods of distribution of the recyclate in the composite structure (1, 2, and 3 layers with a constant share of 5% of the recyclate) were used in the tested materials. To determine the stress values at which critical failures of the tested materials are initiated in the bending test, an analysis was carried out using the Kolmogorov–Sinai (EK-S) metric entropy calculations. The analysis results showed that for each of the above-mentioned variants of the tested epoxy–glass composites, the onset of critical changes occurring in the material structure occurs below the recorded values of the flexural strength Rmg. The decrease in the RmgK-S value in relation to Rmg is different for different material variants and depends mainly on the % content of rubber recyclate and the amount and method of decomposition of rubber recyclate in the layers of the analyzed materials. The research showed that the introduction of rubber recyclate into the composition of composites has a positive effect on their strength properties. This process allows for the efficient use of hard to degrade waste and opens up the possibility of using the newly developed materials in many industrial sectors.