Application of Piezoelectric Fast Tool Servo for Turning Non-Circular Shapes Made of 6082 Aluminum Alloy

Abstract

The paper presents the design and testing of a new servo drive for turning non-circular shapes. The presented solution is based on a commercially available piezoelectric drive unit with a stroke equal to 1000 µm and a resonant frequency of 150 Hz. The device was used in a conventional turning lathe and installed in a tool turret. The performance of the proposed tool was tested while turning multiple non-circular contours from a cylindrical shaft made of 6082 aluminum alloy. The machining accuracy was tested online using a laser sensor and offline with a coordinate measuring machine. The additional aim of those tests was also to verify if the application of an online transducer can allow a confident preliminary assessment of as-machined geometry. The drive positioning accuracy was compensated using 6th order polynomial what resulted in the fabrication of non-circular contours with an accuracy of no less than 39.8 µm when operating below the limit frequency of the drive (<9 Hz). It was found out that the deviations of the profile from ideal geometries increase linearly with frequency when turning at higher than the limit frequency.