Bavenite from Transbaykal

Komarova, G.N.; Moleva, V.A.; Rudnitskaya, E.S.; Dmitriyeva, M. T.

doi:10.1080/00206816809474863

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…7) mainly quartz (COD#96-101-1160 [17] and small amount of Bavenite (COD#96-900-7488 [39]). Bavenite, Al 2 Be 2 Ca 4 Si 9 H 3 O 28 is a mixed oxide and the IR spectrum of bavenite remains unchanged up to 900°C [40]. It exhibits good physical, chemical and thermal properties from room temperature to elevated temperature.…”

Section: Mineralogical Analysismentioning

confidence: 99%

Manufacture of Refractory Brick From Locally Available Red Clay Blended With White Portland Cement and Its Performance Evaluation

Samad¹

2021

GEOMATE

View full text Add to dashboard Cite

In this paper, refractory bricks were developed by using locally obtainable materials like red clay and glass sand in Bangladesh. The Preliminary investigation was conducted by measuring the compressive strength of bricks produced by adding a range of materials with red clay in different proportions. It was found that the brick containing 30% white Portland cement and 10% glass sand with red clay (60%) demonstrated the highest compressive strength (36.20 mpa). The suitability of refractory bricks was evaluated by examining their physical and thermal properties. The evaluation of these parameters revealed that the properties are suited with refractory requirements such as low water absorption (4.58%), moderate apparent porosity (13.32%), preferable bulk density (2.64 gm/cm 3 ), less linear shrinkage (3.10%), better refractoriness (1408 ºC), thermal conductivity (1.3 W/m.K) and thermal shock resistance (15 cycles). The mineralogical analysis carried out by XRD exhibits the presence of Quartz and Bavenite phase. The performance evaluation shows that this brick is able to fit most of the criteria of refractory brick needed for practical purposes. Since local materials were utilized, the proposed method can be used for the manufacture of low-cost refractory brick in Bangladesh.

show abstract

Section: Mineralogical Analysismentioning

confidence: 99%

Manufacture of Refractory Brick From Locally Available Red Clay Blended With White Portland Cement and Its Performance Evaluation

Samad¹

2021

GEOMATE

View full text Add to dashboard Cite

show abstract

Bavenite from Transbaykal

Cited by 1 publication

References 0 publications

Manufacture of Refractory Brick From Locally Available Red Clay Blended With White Portland Cement and Its Performance Evaluation

Manufacture of Refractory Brick From Locally Available Red Clay Blended With White Portland Cement and Its Performance Evaluation

Contact Info

Product

Resources

About