Biosorption of lead (II) from aqueous solution by cone biomass of Pinus sylvestris

Ucun, Handan; Bayhana, Y.Kemal; Kaya, Yusuf; Çakıcı, Avni; Algur, Ömer Faruk

doi:10.1016/s0011-9164(03)80038-3

Cited by 178 publications

(86 citation statements)

References 13 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…concentration approach 200-500 mg/L in the industrial wastewaters. This value is very high in relation to the water quality standards and it should be reduced to a range of 0.1-0.05 mg/L (Ucun et al 2003;Vilar et al 2005;Ö zaçar et al 2008).…”

Section: Introductionmentioning

confidence: 95%

Applications on agricultural and forest waste adsorbents for the removal of lead (II) from contaminated waters

Saka

Şahi̇n

Küçük

2012

Int. J. Environ. Sci. Technol.

138

View full text Add to dashboard Cite

At present, there is growing interest in using low cost, commercially available materials for the adsorption of heavy metals. The major advantages of adsorption technologies are its effectiveness in reducing the concentration of heavy metal ions to very low levels and the use of inexpensive adsorbent materials. In this review, agricultural and forest waste adsorbents were used to remove Pb 2? ions in wastewater treatment, and their technical feasibilities were reviewed in studies mainly from 2000 to 2010. They all were compared with each other by metal binding capacities, metal removal performances, sorbent dose, optimum pH, temperature, initial concentration and contact time. Although commercial activated carbon is widely used in wastewater treatment applications, it has high costs. The use of agricultural by-products as adsorbent material to purify heavy metal contaminated water has become increasingly popular through the past decade because they are less expensive, biodegradable, abundant and efficient. Instead of activated carbon, this study was focused on the inexpensive materials such as agricultural and forest waste. It was shown that these alternative adsorbents had sufficient binding capacity to remove Pb 2? ions from wastewater.

show abstract

Section: Introductionmentioning

confidence: 95%

Applications on agricultural and forest waste adsorbents for the removal of lead (II) from contaminated waters

Saka

Şahi̇n

Küçük

2012

Int. J. Environ. Sci. Technol.

138

View full text Add to dashboard Cite

show abstract

“…2) can be used to assess the dependency of the process on the sorbed Pb(II) or Ni(II). where k 2 is the overall rate constant for the adsorption process [dm 3 (mg min -1 )], q e is the amount of metal ion adsorbed at equilibrium (mg g -1 ) and q t is the amount of metal ion adsorbed at any time t (mg g -1 ). Re-arrangement of equation (2) The initial sorption rate, h , as t → 0 can be defined as in equation (4) .…”

Section: Adsorption Kineticsmentioning

confidence: 99%

“…Heavy metals such as lead and nickel are but two of the species of particular concern environmentally and are discharged to the environment in the wastewaters associated with industries such as mineral processing, non-ferrous metal porcelain enamelling, electroplating, copper sulphate manufacture, ammunitions and battery manufacture [2]. Discharge concentrations for both Pb(II) and Ni(II) can range from 3.4 to 900 mg dm -3 [3]. Pb(II) accumulates in vital organs and bones and causes a number of diseases ranging from anaemia to nervous system degeneration [4].…”

Section: Introductionmentioning

confidence: 99%

Design of a novel cellulose-based adsorbent for use in heavy metal recovery from aqueous waste streams

O’Connell¹,

Birkinshaw²,

O’Dwyer³

2006

WIT Transactions on Ecology and the Environment, Vol 95

View full text Add to dashboard Cite

Currently, significant metal-laden waste streams are produced from a number of industries with obvious consequences for the environment. A variety of techniques are being used to treat these wastewaters. One such technique is adsorption and recent focus in this area has been around the preparation of selective adsorbents based on naturally occurring support materials. In our work, a regenerated cellulose wood pulp was grafted with the vinyl monomer glycidyl methacrylate (GMA) and was further functionalised with imidazole to produce a novel adsorbent material, cellulose-g-GMA-imidazole. A series of adsorption studies were carried out on the cellulose-g-GMA-imidazole to assess its capacity in the separate removal of lead and nickel ions (Pb(II), Ni(II)) from aqueous solution. Cellulose-g-GMA-imidazole sorbent showed an uptake of approximately 72 mg g -1 of Pb(II) and 45 mg g -1 of Ni(II) from aqueous solution. The adsorption process in both cases followed the Langmuir model of adsorption and Pb(II) uptake occurred within 30 minutes while Ni(II) uptake was considerably slower at 400 minutes for maximum uptake. In both cases pseudo second order kinetics best describes the overall process for each metal uptake. The cellulose-g-GMA-imidazole material shows significant promise as a sorbent for the removal of both Ni(II) and Pb(II) and other heavy metal ions from aqueous and waste streams.

show abstract

“…These materials including sugarcane bagasse, risk husk, tea leaves, bamboo dust, maize cob, tree sawdust [3], zeolite [4,5], bentonite [6,7], montmorillonite [8], Cephalosporium aphidicola [9], Pinus sylvestris [10], Saccharomyces cerevisiae [11], and so forth. Despite the mentioned materials, Ficus religiosa leaf powder can also be utilized as adsorbents to remove heavy metals from aqueous solution [12,13,14,15,16,17].…”

Section: Introductionmentioning

confidence: 99%

Adsorption and Removal of Zinc (II) from Aqueous Solution Using Peepal (Ficus religiosa) Leaf Derived Carbon

2017

IJMTER

View full text Add to dashboard Cite

Abstract-The present work is an attempt to determine the feasibility and reliability of Peepal (Ficus religiosa) Leaf Derived Carbon utilized as an adsorbent for the removal of zinc (II) from aqueous solution. The effects of solution pH, adsorbent dose, temperature, initial metal ionconcentration and contact time on the adsorption process with respect to the zinc (II) removal were investigated. The optimum conditions obtained were 30 min contact time, 0.8g adsorbent dose, 45 0 C, 0.12M Zn and pH 7 for zinc removal. Experimental equilibrium data were analyzed by the Langmuir and Freundlich isotherm models. The results obtained from the experimental work showed that biomass carbon derived from peepal leaves are transformed into adsorbent for removing metal ions from the aqueous solution. Peepal leaf carbon show promising results in removing zinc (II) from aqueoussolution, thus this material could be used as low cost adsorbent to replace the expensive commercial activated carbon during adsorption process.

show abstract

Biosorption of lead (II) from aqueous solution by cone biomass of Pinus sylvestris

Cited by 178 publications

References 13 publications

Applications on agricultural and forest waste adsorbents for the removal of lead (II) from contaminated waters

Applications on agricultural and forest waste adsorbents for the removal of lead (II) from contaminated waters

Design of a novel cellulose-based adsorbent for use in heavy metal recovery from aqueous waste streams

Adsorption and Removal of Zinc (II) from Aqueous Solution Using Peepal (Ficus religiosa) Leaf Derived Carbon

Contact Info

Product

Resources

About