Biosynthesis of ZnO and CuO nanoparticles using sunflower petal extract

Khoshsang, Hossein; Abbasi, Khadijeh; Ghaffarinejad, Ali

doi:10.1016/j.inoche.2023.111083

Cited by 6 publications

(2 citation statements)

References 40 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Table S2 concisely summarizes the recent preparation procedure employed for synthesizing ZnO NMs. Various methods can be employed for ZnO synthesis, including vapor deposition [37], hydrothermal synthesis [38], sol-gel [38], biosynthesis [39], the polyol chemistry process [40], and mechanochemical processes [12]. The sol-gel method is a straightforward approach that allows control over particle size and morphology through systematically monitoring reaction parameters [41].…”

Section: Introductionmentioning

confidence: 99%

Influence of pH on Room-Temperature Synthesis of Zinc Oxide Nanoparticles for Flexible Gas Sensor Applications

Mechai,

Al Shboul,

Bensidhoum

et al. 2024

Chemosensors

View full text Add to dashboard Cite

This research contributes to work on synthesizing zinc oxide nanoparticles (ZnO NPs) at room temperature (RT) and their utilization in flexible gas sensors. RT ZnO NP synthesis with a basicity solution (pH ≈ 13) demonstrates an efficient method for synthesizing well-crystalline ZnO NPs (RT.pH13) comparable to those synthesized by the hydrothermal method (hyd.C). The RT.pH13 achieved a high thermal stability with minimal organic reside impurities (~4.2 wt%), 30–80 nm particle size distribution, and a specific surface area (14 m2 g−1). The synthesized pre- and post-calcinated RT.pH13 NPs were then incorporated into flexible sensors for gas sensing applications at ambient conditions (RT and relative humidity of 30–50%). The pre-calcinated ZnO-based sensor (RT.pH13) demonstrated superior sensitivity to styrene and acetic acid and lower sensitivity to dimethyl-6-octenal. The calcinated ZnO-based sensor (RT.pH13.C) exhibited lower sensitivity to styrene and acetic acid, but heightened sensitivity to benzene, acetone, and ethanol. This suggests a correlation between sensitivity and structural transformations following calcination. The investigation of the sensing mechanisms highlighted the role of surface properties in the sensors’ affinity for specific gas molecules and temperature and humidity variations. The study further explored the sensors’ mechanical flexibility, which is crucial for flexible Internet of Things (IoT) applications.

show abstract

Section: Introductionmentioning

confidence: 99%

Influence of pH on Room-Temperature Synthesis of Zinc Oxide Nanoparticles for Flexible Gas Sensor Applications

Mechai,

Al Shboul,

Bensidhoum

et al. 2024

Chemosensors

View full text Add to dashboard Cite

show abstract

“…Wang and co-workers [58] investigated the optical-electrical characteristics of ZnS/ZnO films. Khoshsang and co-workers [59] carried out the biosynthesis of ZnO and CuO nanoparticles using sunflower petal extract. Raha and co-workers [60] reviewed the ZnO nanostructured materials and their potential applications, focusing on the progress, challenges, and perspectives.…”

Section: Introductionmentioning

confidence: 99%

Strong Interface Interaction of ZnO Nanosheets and MnSx Nanoparticles Triggered by Light over Wide Ranges of Wavelength to Enhance Their Removal of VOCs

Ma,

Zhang,

Gao

et al. 2023

Coatings

View full text Add to dashboard Cite

The characteristics of the surface and interface of nanocomposites are important for exerting multi-functional properties and widening interdisciplinary applications. These properties are mainly depending on the electronic structures of materials. Some key factors, such as the surface, interface, grain boundaries, and defects take vital roles in the contribution of desired properties. Due to the excellent sensitivity of the QCM (quartz crystal microbalance) device, the surface and interface features of the nanocomposite were studied with the aid of the gas-response of the sensors (Sensor’s Gas-Sensitivity) in this work. To make full use of the visible light and part of NIR, a ZnO/MnSx nanocomposite was constructed using hydrothermal synthesis for narrowing the bandgap width of wide bandgap materials. The results indicated that the absorbance of the resulting nanocomposite was extended to part of the NIR range due to the introduction of impurity level or defect level, although ZnO and MnS belonged to wide bandgap semiconductor materials. To explore the physical mechanism of light activities, the photoconductive responses to weak visible light (650 nm, etc.) and NIR (near-infrared) (808 nm, 980 nm, and 1064 nm, etc.) were studied based on interdigital electrodes of Au on flexible PET (polyethylene terephthalate) film substrate with the casting method. The results showed that the on/off ratio of ZnO/MnSx nanocomposite to weak visible light and part of NIR light were changed by about one to five orders of magnitude, with changes varying with the amount of MnSx nanoparticle loading due to defect-assisted photoconductive behavior. It illustrated that the ZnO/MnSx nanocomposite easily produced photo-induced free charges, effectively avoiding the recombination of electrons/holes because of the formation of strong built-in electrical fields. To examine the surface and interface properties of nanocomposites, chemical prototype sensor arrays were constructed based on ZnO, ZnO/MnSx nanocomposite, and QCM arrays. The adsorption response behaviors of the sensor arrays to some typical volatile compounds were examined under a similar micro-environment. The results exhibited that in comparison to ZnO nanosheets, the ZnO nanosheets/MnSx nanocomposite increased adsorption properties to some typical organic volatile compounds significantly. It would have good potential applications in photo-catalysts, self-cleaning films, multi-functional coatings, and organic pollutants treatment (VOCs) of environmental fields for sustainable development. It provided some reference value to explore the physical mechanism of materials physics and photophysics for photo-active functional nanocomposites.

show abstract