Biplanar Shim Coil Design for 1.5 T Permanent Magnet of <i>In Vivo</i> Animal MRI

You, Xiao Fei; Hu, Li; Yang, Wen; Wang, Zheng; Wang, Hui Xian

doi:10.1109/tasc.2010.2041537

Cited by 12 publications

(2 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In general, for a high-field medical NMR imaging equipment magnet, the peak-to-peak value of the B 0 field in a spherical imaging volume (usually 50 cm diameter spherical volume (DSV)) should be less than 10 ppm [1]. High uniformity of the static magnetic field B 0 can be achieved in two ways: passive shimming, and active shimming.…”

Section: Introductionmentioning

confidence: 99%

“…According to measurements of the spatial distribution characteristics of the static magnetic field, the steel pieces are placed in low-field parts of the magnet, producing a magnetizing field in the DSV to compensate for the inhomogeneity of the B 0 field. Active shimming technology, which improves the magnetic field by adding the magnetic fields generated by a series of electrical coils to the static magnetic field B 0 , can achieve further improvements in uniformity [1,2].…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Active shimming method for a 21.3 MHz small-animal MRI magnet

Chen

Xia

Miao

et al. 2017

Meas. Sci. Technol.

View full text Add to dashboard Cite

In a 21.3 MHz animal nuclear magnetic resonance (NMR) analyzer and imaging system, high uniformity of the static field B0 is a crucial prerequisite for obtaining high-quality images and detecting weak signals with short relaxation time. Using only passive shimming and gradient shimming, it is impossible to achieve perfect B0 uniformity. This paper presents an approach involving high-order active shimming for an NMR analyzer and an imaging magnet. The diameter spherical volume (DSV) of the magnet is only 60 mm. The spherical harmonic function is introduced to analyze the magnetic field and provide a foundation for active shimming. Eleven pairs of bi-planar active shim coils (X, Y, Z, XZ, YZ, Z2, X2 + Y2, X2 − Y2, Z3, Z4, Z5) were designed using the target field-and stream-function methods, and coils were manufactured with printed circuit board technology in this research. The magnetic field created by these electrified shim coils compensates effectively and accurately for the static magnetic field B0. The full width at half maximum of the resonance spectrum was used to measure the shimming effect. The results of practical shimming experiments in a 21.3 MHz animal NMR analyzer and imaging device showed that this new approach helps to reduce inhomogeneity from 24 ppm (24 × 10−6) to 0.39 ppm (0.39 × 10−6) over a 60 mm DSV, which meets the requirements of imaging and analytical practice.

show abstract

Section: Introductionmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%