Bridgeless PFC implementation using one cycle control technique

Lu, Bing; Brown, R. G.; Soldano, M.

doi:10.1109/apec.2005.1453073

Cited by 113 publications

(27 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…1 has to be sensed. There are some useful ways to sense input voltage, such as the voltage divider, line frequency transformer, optocoupler, and so on [7]. In this system, the voltage divider can not be employed for input voltage sensing because the voltage potential of the output ground is different from that of the input terminals.…”

Section: Introductionmentioning

confidence: 99%

Traction Motor-Inverter Utilized Battery Charger for PHEVs

Woo¹,

Kim²,

Kang³

et al. 2013

Journal of Power Electronics

View full text Add to dashboard Cite

Most eco-friendly cars can adopt the concept of an integrated battery charger (IBC), which uses currently available motor drive systems. The IBC has a lot of strong points such as low cost and minimum space for the high voltage battery charger. On the other hand, it also has some defects caused by its structure. In this paper, the shortcomings of the conventional IBC for PHEVs with interior permanent magnet motors are discussed, and two advanced IBCs with improved performance are presented. Compared with the conventional IBC, the two advanced IBCs have plenty of strengths such as low common noise, high efficiency, simple sensing methods, etc. Then, the digital control algorithm is modified and a power loss calculation is carried out with simulation software. Finally, experimental results are provided to show the performance of the IBC systems.

show abstract

Section: Introductionmentioning

confidence: 99%

Traction Motor-Inverter Utilized Battery Charger for PHEVs

Woo¹,

Kim²,

Kang³

et al. 2013

Journal of Power Electronics

View full text Add to dashboard Cite

show abstract

“…Many topologies have been introduced to reduce the conduction loss of the rectifier bridge. Bridgeless PFC generates less conduction loss compared with the conventional boost PFC (CB PFC), since there are only two voltage drop of semiconductors in the current path [16] - [18].…”

Section: Introductionmentioning

confidence: 99%

The Power Factor Correction Improvement for a Single Phase AC/DC Converter Using an Enabling Window Control

Jegadeeswari¹,

Tjprc²

2018

IJMPERD

View full text Add to dashboard Cite

“…Bridgeless circuits with boost converter and buck converters are present. In boost converter the dc output voltage is higher than the peak input voltage and it cannot be used for low power application such as for telecommunication [3]. By using the buck converter the input current does not track the input voltage at zero crossing of the input voltage [4].…”

Section: Introductionmentioning

confidence: 99%

Bridgeless CUK Rectifier with Output Voltage Regulation using Fuzzy controller

R.V¹

2013

IOSR-JEEE

View full text Add to dashboard Cite

Bridgeless PFC implementation using one cycle control technique

Cited by 113 publications

References 7 publications

Traction Motor-Inverter Utilized Battery Charger for PHEVs

Traction Motor-Inverter Utilized Battery Charger for PHEVs

The Power Factor Correction Improvement for a Single Phase AC/DC Converter Using an Enabling Window Control

Bridgeless CUK Rectifier with Output Voltage Regulation using Fuzzy controller

Contact Info

Product

Resources

About