Calibration Model Optimization for Strain Metrology of Equal Strength Beams Using Deflection Measurements

Abstract

Strain sensors, especially fiber Bragg grating (FBG) sensors, are of great importance in structural health monitoring, mechanical property analysis, and so on. Their metrological accuracy is typically evaluated by equal strength beams. The traditional strain calibration model using the equal strength beams was built based on an approximation method by small deformation theory. However, its measurement accuracy would be decreased while the beams are under the large deformation condition or under high temperature environments. For this reason, an optimized strain calibration model is developed for equal strength beams based on the deflection method. By combining the structural parameters of a specific equal strength beam and finite element analysis method, a correction coefficient is introduced into the traditional model, and an accurate application-oriented optimization formula is obtained for specific projects. The determination method of optimal deflection measurement position is also presented to further improve the strain calibration accuracy by error analysis of the deflection measurement system. Strain calibration experiments of the equal strength beam were carried out, and the error introduced by the calibration device can be reduced from 10 με to less than 1 με. Experimental results show that the optimized strain calibration model and the optimum deflection measurement position can be employed successfully under large deformation conditions, and the deformation measurement accuracy is improved greatly. This study is helpful to effectively establish metrological traceability for strain sensors and furthermore improve the measurement accuracy of strain sensors in practical engineering scenarious.

Conformal Fabrication of Thick Film Platinum Strain Gauge Via Error Regulation Strategies for In Situ High-Temperature Strain Detection

“…The curved metallic substrate was subjected to all degrees of freedom on one end, while the other end experienced strain through a load applied to the CPTFSG. In the current study of strain sensors on planes, strain sensors can be calibrated using equal-strain beams or beam-theoretical computations to determine the amount of strain applied to the sensor. , On the contrary, strains on curved surfaces are more challenging to calculate than those on planes. In this work, a commercial strain transducer was installed on the back of the curved substrate for strain calibration.…”

Bidirectional large strain monitoring using a novel graphene film-based patch antenna sensor

“…Finally, a highly conductive thin film composed of multiple layers of graphene was obtained through highpressure rolling. In addition, as a carbon material, graphene has good chemical stability and adaptability to complex environments compared with metal materials [40]. Based on the four-probe method [41], the graphene film showed a high conductivity of 1.1 × 10 6 S m −1 .…”

“…The patch antenna was pasted onto an equal strength beam, and the loading process was conducted by adding weights. Equal strength beams were commonly used in the research and calibration of strain sensors [40]. The strain of the beam was transmitted to the antenna, causing a change in the size of the antenna patch and a shift in its resonant frequency.…”

Research on a Precision Calibration Model of a Flexible Strain Sensor Based on a Variable Section Cantilever Beam

“…Yan et al [ 22 ] adopted analytical methods such as finite element analysis and measurement experiments to solve the problems existing in the measurement model. By modifying the conventional deflection method measurement model, they obtained the engineering measurement application model.…”