Calphad-type assessment of the Sb–Sn–Zn ternary system

Zobač, Ondřej; Sopoušek, Jiří; Kroupa, Aleš

doi:10.1016/j.calphad.2015.08.002

Cited by 9 publications

(2 citation statements)

References 16 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…According to the phase diagram of Al-Zn [ 18 ], zinc is one of the promising alloying elements because it is well dissolved in aluminum and almost not dissolved in solid tin [ 19 ] ( Figure 1 ). Therefore, Zn cannot strongly affect the plasticity of Sn inclusions.…”

Section: Introductionmentioning

confidence: 99%

Tribotechnical Properties of Sintered Antifriction Aluminum-Based Composite under Dry Friction against Steel

et al. 2021

View full text Add to dashboard Cite

The disadvantage of antifriction Al–Sn alloys with high tin content is their low bearing capacity. To improve this property, the aluminum matrix of the alloys was alloyed with zinc. The powder of Al–10Zn alloy was blended with the powder of pure tin in the proportion of 40/60 (wt.%). The resulting mixture of the powders was compacted in briquettes and sintered in a vacuum furnace. The sintered briquettes were subjected to subsequent pressing in the closed press mold at an elevated temperature. After this processing, the yield strength of the sintered (Al–10Zn)–40Sn composite was 1.6 times higher than that of the two-phase Al–40Sn one. The tribological tests of the composites were carried out according to the pin-on-disk scheme without lubrication at pressures of 1–5 MPa. It was established that the (Al–10Zn)–40Sn composite has higher wear resistance compared with the Al–40Sn one. However, this advantage becomes insignificant with an increase in the pressure. It was found that the main wear mechanism of the investigated composites under the dry friction process is a delamination of their highly deformed matrix grains.

show abstract

Section: Introductionmentioning

confidence: 99%

Tribotechnical Properties of Sintered Antifriction Aluminum-Based Composite under Dry Friction against Steel

et al. 2021

View full text Add to dashboard Cite

show abstract

“…During the past decades so many combination and also different composition of binary systems based on Sb were studied (Liu et al, 2013;Gierlotka, 2014) and later ternary systems (Zobač et al, 2015;Guo et al, 2016).…”

Section: Introductionmentioning

confidence: 99%

Propiedades eléctricas de las aleaciones ternarias Bi-Ge-Sb y Al-Cu-Sb

et al. 2017

View full text Add to dashboard Cite

Electrical properties of ternary Bi-Ge-Sb and Al-Cu-Sb alloys. This paper presents review of electrical properties of two ternary systems based on Sb, ternary Bi-Ge-Sb and Al-Cu-Sb system. Beside electrical properties in paper are presented microstructures of both systems observed with light optical microscopy. On four samples microstructural analysis was carried out by scanning electron microscopy combined with energy dispersive spectrometry and X-ray powder diffraction technique. Moreover, micro hardness of selected alloys from the ternary Bi-Ge-Sb system was determined using Vickers hardness tests. RESUMEN: Propiedades eléctricas de las aleaciones ternarias Bi-Ge-Sb y Al-Cu-Sb.Este artículo presenta el estudio de las propiedades eléctricas de dos sistemas ternarios basados en antimonio, Bi-Ge-Sb y Al-Cu-Sb. Además de las propiedades eléctricas, en el artículo se presenta las microestructuras observadas por microscopía óptica. Se utilizaron cuatro muestras para el análisis de la microestructura utilizando MEB, EDS y DRX. Además, se determinó la microdureza de muestras seleccionadas de la aleación ternaria Bi-Ge-Sb, la dureza se determinó utilizando ensayos Vickers.

show abstract

Diffusivities and atomic mobilities in Sn–Ag–In and Sn–Ag–Sb melts

Chen

Zhang

2016

Calphad

View full text Add to dashboard Cite

Calphad-type assessment of the Sb–Sn–Zn ternary system

Cited by 9 publications

References 16 publications

Tribotechnical Properties of Sintered Antifriction Aluminum-Based Composite under Dry Friction against Steel

Tribotechnical Properties of Sintered Antifriction Aluminum-Based Composite under Dry Friction against Steel

Propiedades eléctricas de las aleaciones ternarias Bi-Ge-Sb y Al-Cu-Sb

Diffusivities and atomic mobilities in Sn–Ag–In and Sn–Ag–Sb melts

Contact Info

Product

Resources

About