Can the Velocity of a 1RM Hang Power Clean Be Used to Estimate a 1RM Hang High Pull?

Abstract

Suchomel, TJ, Techmanski, BS, Kissick, CR, and Comfort, P. Can the velocity of a 1RM hang power clean be used to estimate a 1RM hang high pull? J Strength Cond Res 38(7): 1321–1325, 2024—The purpose of this study was to estimate the 1-repetition maximum hang high pull (1RM HHP) using the peak barbell velocity of a 1RM hang power clean (HPC). Fifteen resistance-trained men (age = 25.5 ± 4.5 years, body mass = 88.3 ± 15.4 kg, height = 176.1 ± 8.5 cm, relative 1RM HPC = 1.3 ± 0.2 kg·kg−1) with previous HPC experience participated in 2 testing sessions that included performing a 1RM HPC and HHP repetitions with 20, 40, 60, and 80% of their 1RM HPC. Peak barbell velocity was measured using a linear position transducer during the 1RM HPC and HHP repetitions performed at each load. The peak barbell velocity achieved during the 1RM HPC was determined as the criterion value for a 1RM performance. Subject-specific linear regression analyses were completed using slope-intercept equations created from the peak velocity of the 1RM HPC and the peak barbell velocities produced at each load during the HHP repetitions. The peak barbell velocity during the 1RM HPC was 1.74 ± 0.30 m·s−1. The average load-velocity profile showed that the estimated 1RM HHP of the subjects was 98.0 ± 19.3% of the 1RM HPC. Although a 1RM HHP value may be estimated using the peak barbell velocity during the HPC, strength and conditioning practitioners should avoid this method because of the considerable variation within the measurement. Additional research examining different methods of load prescription for weightlifting pulling derivatives is needed.