The authors present the formation of Fabry-Pérot cavity in single GaAs nanowire prepared by selective-area metal organic vapor phase epitaxy. The grown nanowires with hexagonal cross section are highly uniform and vertically oriented. Microphotoluminescence measurements of single GaAs nanowire exhibit periodic peaks in the intensity, which are suggestive of the longitudinal modes of a Fabry-Pérot cavity. The cavity is formed along the length of the nanowire and the ͑111͒ facets of both ends act as reflecting mirrors. Additionally, optical waveguides in GaAs nanowires were also observed. © 2007 American Institute of Physics. ͓DOI: 10.1063/1.2787895͔ Semiconductor nanowires have been attracting great interests because they are potentially used as building blocks in nanoelectronics and photonics. [1][2][3][4] Recently, semiconductor nanolasers working in ultraviolet region based on ZnO ͑Ref. 3͒ and CdS͑Ref. 4͒ single nanowires were reported. These applications require that the fabricated nanowires should be uniform and flat enough to form Fabry-Pérot cavities. We recently proposed and demonstrated an alternative method of preparing semiconductor nanowires by using selective-area metal organic vapor phase epitaxy ͑SA-MOVPE͒. 5-8 Compared to the conventional vapor-liquid-solid growth, 9,10 this is a catalyst-free approach and only relies on the thermal decomposition of source materials. Furthermore, since this method fully utilizes the nature of epitaxial growth, it is expected to exhibit superior crystalline quality as well as good controllability of the growth with atomic precision to form abrupt doping profiles and heterojunctions, including vertical and lateral heterostructures. [6][7][8] In this letter, we fabricated GaAs nanowires with uniform and smooth surfaces by SA-MOVPE. Microphotoluminescence ͑ PL͒ measurements reveal the formation of Fabry-Pérot cavity modes in individual GaAs nanowires, caused by the refractive index difference between the wire and the surrounding. Thus, GaAs nanowires may be candidate materials for achieving stimulated emission or lasing, especially in near-infrared region.SA-MOVPE growth of GaAs nanowires started with the deposition of 30 nm SiO 2 layer by plasma sputtering on ͑111͒B GaAs substrate. Then SiO 2 was partially removed by electron beam lithography and wet chemical etching. The mask pattern of SiO 2 had circular opening and they were arranged in a triangular lattice. The diameter of the grown nanowires was directly related to that of the opening holes. In addition, we controlled the nanowire length by adjusting the opening pitch and growth condition. Finally, the patterned substrates were loaded into a horizontal low-pressure MOVPE system working at 0.1 atm using trimethylgallium ͑TMG͒ and arsine ͑AsH 3 ͒ as source materials. Typical partial pressures were 9.6ϫ 10 −7 and 2.5ϫ 10 −4 atm for TMG and AsH 3 , respectively. The growth temperature and growth time for GaAs nanowires were 750°C and 60 min. Typical freestanding GaAs nanowires grown on ͑111͒B GaAs substrate by MOVPE...