Communication-Less Primary and Secondary Control in Inverter-Interfaced AC Microgrid: An Overview

Abstract

Inverters in Microgrids (MGs) face significant challenges during their parallel operations; such as accurate power sharing, deviations in system voltage magnitude and frequency, imbalance between generation and load demand. To solve these techno-economic challenges, hierarchical control structures are implemented in MGs. The structure consists of three layers as primary, secondary and tertiary controls. The control approach can be either communication-based or communication-less at the various layers. The use of communication at primary and secondary layers faces problems like communication latency, data drop-up, and expense issues. On the other hand, improved decentralized control techniques being communication-less can avoid the disadvantages of using communication. This paper presents an insight into the limitations with the communication-based approach by briefing about the centralized and distributed control techniques at the secondary control layer. Subsequently, the communication-less control techniques and algorithms to achieve accurate power sharing along with restoration of MG voltage and frequency are described. A comparison among different decentralized droopbased power sharing methods in the primary control layer are done based on review and simulations. In addition to that, improved communication-less secondary restoration techniques are explained. Finally, future research directions in these areas are listed, aiming to improve the reviewed techniques.

Fusion of Model-free Reinforcement Learning with Microgrid Control: Review and Vision

“…Distributed control algorithms require the connected communication graph of microgrids. They also have a reduced convergence speed as the network grows [35]. In decentralized control, the control signals are generated based on local measurements.…”

Recent control techniques and management of AC microgrids: A critical review on issues, strategies, and future trends

“…The block diagram of the virtual impedance droop method in the voltage control loop is illustrated in Figure 16. More details of virtual impedance in the DER control operating system are available in References 82,129,130. The VSI output requires reference voltage U ref can be expressed as follows: where is the output impedance of VSC, U ref is the output reference voltage under the no‐load condition and 0 is the output droop current.…”

“…Although, THD of the VSI output amplitude voltage would be higher 130 where ω c is the corner angular frequency of high pass‐filter (HPF).…”

Novel control solutions for DoS attack delay mitigation in grid-connected and standalone inverters

“…Besides, without an attack detection strategy, the local controller would still be operating under the imposed conditions. Yet, the primary controller is usually the one with the highest bandwidth and highest processing speed [17]. This control layer could clearly take much faster actions than the others to mitigate the attack.…”