Comparative Analysis of Drilling Behaviour of Synthetic and Natural Fiber‐Based Composites

Abstract

For comparison, the drilling behaviour of abaca fiber-reinforced polymer (AFRP) composites and Kevlar-reinforced epoxy polymer (KFRP) composites has been studied in the specified experimental condition. The different geometrical drilling tools have been used for the investigation, namely, candlestick (T1), core (T2), standard twist drill (T3), and step cone (T4). The tool feed of 30, 45, and 60 m/min and rotational speed of 1000, 1500, and 2000 rpm have been used for the investigation. The thrust force is chosen as a response parameter for this study. The results revealed that, at lesser rotational speed and tool feed, the thrust force has declined. The result obtained correlates with the abaca fiber-based systems. However, the thrust force of KFRP is higher compared to AFRP composite systems. The axial force generated by candlestick drill is minimal compared to the other drill bits. The following may be responsible for lower thrust force: (1) the axial force distributes circumferential of the cutting tool instead of focusing at the center and (2) the interfacial adhesiveness between the matrix and the fiber is higher. The optimization of drilling process parameters, namely, tool feed and rotational speed on thrust force, has been studied. The results reveal that the tool feed contributed more to axial force compared to rotational speed.

Processing of Aluminium-Silicon Alloy with Metal Carbide as Reinforcement through Powder-Based Additive Manufacturing: A Critical Study

“…The major challenge in processing aluminium-based alloys in SLM is reflectivity, low melting point, and interaction with oxygen in the environment [ 15 , 38 , 107 – 109 ]. Only 10% of the input energy is utilized to melt the powder, and the remaining is reflected.…”

Influences of various natural fibers on the mechanical and drilling characteristics of coir-fiber-based hybrid epoxy composites

“…Drilling natural fiber composites is a critical step in the production of natural products. In the most of drilling of natural fiber composites, the influences of various drilling parameters on the delamination factors and surface damages were only discussed [40,41]. In this research, two drilling characteristics, ovality and delamination factors are discussed to enhance the fabrication characteristics using natural fibers.…”

Drilling Parameters and Post-Drilling Residual Tensile Properties of Natural-Fiber-Reinforced Composites: A Review

“…There are also some studies specifically comparing synthetic and natural fiber's drilling behaviors. In particular, studies comparing Kevlar-and abaca-reinforced composites during machining have suggested that it is possible to apply different drill geometries, namely, candlestick and core bits, and still obtain appropriate performance, although the thrust forces are markedly different (28.6 N for abaca and 63.18 N for Kevlar composites) [31].…”