2016 IEEE 1st International Conference on Power Electronics, Intelligent Control and Energy Systems (ICPEICES) 2016
DOI: 10.1109/icpeices.2016.7853286
|View full text |Cite
|
Sign up to set email alerts
|

Comparison of different types of SPWM techniques for three phase seven level cascaded H-Bridge inverter

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

0
5
0

Year Published

2018
2018
2024
2024

Publication Types

Select...
5
3
1

Relationship

0
9

Authors

Journals

citations
Cited by 14 publications
(5 citation statements)
references
References 15 publications
0
5
0
Order By: Relevance
“…Random mismatch is caused by the irrational factors of the process, which leads to the change of transistor parameters and cannot be avoided. The mismatch of threshold voltage V th in random mismatch has a great influence on circuit performance and current detection accuracy [17,18]. The circuit based on sense FET proposed in this paper has a large width-to-length ratio between the sensing transistor and power transistor, and the mismatch of the devices is obvious, which will reduce the accuracy.…”
Section: Dem Mismatch Reduction Circuitmentioning
confidence: 99%
See 1 more Smart Citation
“…Random mismatch is caused by the irrational factors of the process, which leads to the change of transistor parameters and cannot be avoided. The mismatch of threshold voltage V th in random mismatch has a great influence on circuit performance and current detection accuracy [17,18]. The circuit based on sense FET proposed in this paper has a large width-to-length ratio between the sensing transistor and power transistor, and the mismatch of the devices is obvious, which will reduce the accuracy.…”
Section: Dem Mismatch Reduction Circuitmentioning
confidence: 99%
“…The modulation method used in the three-phase BLDC motor drive system in this paper is sinusoidal pulse width modulation (SPWM). According to the impulse equivalent principle, the PWM waveform equivalent to the sinusoidal signal can be generated by comparing the isosceles triangular carrier wave with the sinusoidal modulation wave [16][17][18]. The SPWM signal controls the conduction and shutdown of each power transistor in the three-phase inverter bridge circuit to output the desired voltage waveform.…”
Section: Bldc Motor System Structure and Spwm Modulation Modementioning
confidence: 99%
“…Carrier waveforms above the reference are in phase in the phase opposition disposition technique, whereas those below zero are 180 degrees out of phase. CHB-MLI needed six carrier waveforms for seven levels, which are comparable to the modulating sinusoidal signal of 50 Hz waveform [25]. The positive and negative polarity of pulses is created, and these pulses form the switching sequence of the inverter to get the required output voltage.…”
Section: Phase Opposition Disposition Techniquementioning
confidence: 99%
“…An important factor in assessing the performance of the PWM is the total distortion factor of the output voltage harmonics (THD), defined by the ratio of the quadratic sum of the voltage harmonics to the fundamental value of the voltage [8]. (13)…”
Section: Total Distortion Of Thd Voltage Harmonicsmentioning
confidence: 99%