Complementary Sierpinski gasket fractal antenna for dual-band WiMAX/WLAN (3.5/5.8 GHz) applications

Micro & Optical Tech Letters

Gupta

2018

This research work reports the design and development of a novel complementary Sierpinski gasket fractal microstrip antenna array to achieve a good impedance bandwidth and hence support high data rates for 4G/5G MIMO applications. The proposed array is a compact structure (136 mm × 136 mm) designed with complimentary Sierpinski gasket fractal up to two iterations and has a defected ground to improve the antenna's performance. The antenna performance reports an 8.2% bandwidth at the center frequency of 4.94 GHz (4.7434‐5.1514 GHz), a simulated diversity gain of 9.99 allows the proposed array to be well suitable for proposed applications and a directivity of around 5.8 dBi suits good range characteristics. The array designing and optimization is carried out with 3D EM tool CST MWS V'14 using perfect boundary approximations. A simulated low value of envelope correlation coefficient (0.04) indicates that the two antennas in the array provide least interference to each other while radiating. The measured S11 results on a VNA E 5071C show a close match with the simulated results. Thus a compact array size with good bandwidth, radiation characteristics, low ECC and a high diversity gain allow the antenna array to be well suitable for portable MIMO 4G/5G wireless applications specifically for C band and military applications.

Section: Simulated Results and Discussionmentioning

confidence: 99%

Section: Envelope Correlation Coefficientmentioning

confidence: 99%

See 1 more Smart Citation

A complementary Sierpinski gasket fractal antenna array for wireless MIMO portable devices

Micro & Optical Tech Letters

Gupta

2018

“…Therefore instead of increasing the thickness of substrate for bandwidth and gain improvement, which is an expensive method, the main aim of this article is to propose a stacked (multilayered) aperture coupled microstrip antenna (cost-effective without affecting the antenna dimensions much [6, 18, 19]) with slots and a defected ground structure (DGS) for bandwidth improvement to excite an UWB of operation for use in monostatic radar-based microwave imaging applications [20–22].…”

Section: Introductionmentioning

confidence: 99%

Breast tissue tumor detection using “S” parameter analysis with an UWB stacked aperture coupled microstrip patch antenna having a “ + ” shaped defected ground structure

Int. J. Microw. Wireless Technol.

2019

Microwave imaging is an efficient technique that can be used for the early detection of breast cancer. Therefore the current research article presents the microwave imaging of two spherical tumors (radius 4 and 5 mm) in the breast phantom by using the monostatic radar-based technique. This is carried out by using an ultra-wideband (4.9–10.9 GHz), three-layered stacked aperture coupled microstrip antenna (SACMPA) with a defected ground structure to scan the breast phantom and make near field S parameter measurements from a breast phantom. The S parameter data from different locations and at different time intervals are noted and then used in a beam-forming algorithm; Delay and Sum to process it and form a 2D image of the tumor location in the breast phantom using MATLAB. The proposed SACMPA is a three-layered structure with overall dimensions of 37 × 43 × 4.85 mm3 that shows an impedance bandwidth of 6 GHz (4.9–10.9 GHz) and a simulated peak gain of 6.32 dB at a frequency of 9.1 GHz. The validation of S parameters and gain results are done using a Vector Network Analyzer (VNA) and an anechoic chamber. The experimental validation of the proposed microwave imaging procedure is done by allowing the SACMPA to radiate parallel to the breast phantom made from polythene (skin), petroleum jelly (fat), and wheat flour (with water as tumor) and record the S parameters on the VNA. The proposed microwave method is safe for human exposure as the antenna also shows simulated specific absorption rates of 0.271 and 1.115 W/Kg (on the breast phantom) at frequencies of 5.7 and 6.5 GHz, respectively (for 1 g of body tissue).

“…Optimized antenna should be simple enough to get easily fabricated and can be efficiently integrated with radio frequency (RF) devices. Various designs like planar inverted F antenna , fractal , arbitrary shaped have been presented. But they all are complex.…”

Section: Introductionmentioning

confidence: 99%

A dual band stacked aperture coupled antenna array for WLAN applications

Agarwal

Micro & Optical Tech Letters

2017

In this article, a dual band stacked micostrip antenna array is presented for wireless local area network. The antenna is designed and simulated using CST MWSv’14. Stacking of the patches is done to achieve dual band. Further resonant slots are cut on the patch to achieve greater bandwidth. The antenna uses aperture coupled feed with defected ground structure on reduced ground. The antenna is fabricated on FR4 substrate with a dielectric constant of 4.4. The simulated antenna shows a bandwidth of 228.3 MHz from 3.63 to 3.86 GHz and 232 MHz from 5.15 to 5.38 GHz. The simulated gain and envelope correlation coefficient was found to be 6.11 dB and 0.14. The testing of the prototype antenna (to measure S11) is done using vector network analyser. The measured results are matching to the simulated ones. The simulated and the measured results are presented in the article. © 2017 Wiley Periodicals, Inc. Microwave Opt Technol Lett 59:648–654, 2017