Computational fluid dynamics simulation and experimental investigation of a thermoelectric system for predicting influence of applied voltage and cooling water on cooling performance

Abstract

Purpose The purpose of this paper is to experimentally and numerically investigate the cooling performance of the air-to-water thermoelectric cooling system under different working conditions. Design/methodology/approach An air-to-water thermoelectric cooling system was designed and manufactured according to the principle of discrete binary thermoelectric Peltier modules, and the thermal performance, heat transfer rate and average COP values were examined at different cooling water temperatures and voltages applied. Additionally, numerical simulations were performed by computational fluid dynamics approach to investigate the temperature distribution and airflow structure inside the cooling chamber. Findings Analyses were performed using experimental tests and numerical methods. It was concluded that, by decreasing the cooling water temperature from 20 to 5 °C, the average COP increases about 36%. The voltage analysis showed that the efficiency of the system does not always increase as the voltage rises; more importantly, the optimum voltage is different and depends on whether it is desired to increase COP or increase the cooling rate. Originality/value In the studies published in the field of thermoelectric cooling systems, little attention has been paid to the voltage applied and its relationship to other operating conditions. In most cases, the tests are performed at a constant voltage. In this study, several options, including applied voltage and cooling water temperature, were considered simultaneously and their effects on performance have been tested. It was found that under such studies, optimization work should be done to evaluate maximum performance in different working conditions.

Thermo-Electro-Fluidic Simulation Study of Impact of Blower Motor Heat on Performance of Peltier Cooler for Protective Clothing

“…where P P and P b are the power consumption of the Peltier element and the blowers, respectively. For the Peltier cooler of the design shown in Figure 1, the cooling capacity Q c represents the net thermal energy reduction rate in the cold air duct [24], so it can be expressed as…”

“…Three-dimensional steady-state CFD analysis of thermoelectric air cooling chamber with a liquid heat exchanger on the high-temperature side was carried out based on the realizable k − turbulent model [24]. Design verification of a portable Peltier air cooler integrated with the work jacket was performed with CFD simulations [8].…”

Numerical and experimental investigation for enhancing thermal performance of a concentric heat exchanger using different scenarios

“…As stated above, k – ɛ turbulence model was used in the simulations section of the present work and this model could be expressed using the governing equations below where k illustrates turbulent kinetic energy and ɛ demonstrates the rate of dissipation in kinetic energy (Ansys, 2017; Ceviz et al , 2022): …”

Maximizing cooling/heating performance of thermoelectric modules across variable thermal loads via optimal control based on COP curves

“…However, optimization of the cooling/heating performance of the thermoelectric modules has not been taken into consideration. It was found that the efficiency did not increase as the voltage was adjusted [ 17 ]. Those temperature controllers are to minimize the deviations between the desired temperatures and the actual temperatures.…”