Constant-Power versus Constant-Voltage Actuation in Frequency Sweeps for Acoustofluidic Applications

Abstract

Supplying a piezoelectric transducer with constant voltage or constant power during a frequency sweep can lead to different results in the determination of the acoustofluidic resonance frequencies, which are observed when studying the acoustophoretic displacements and velocities of particles suspended in a liquid-filled microchannel. In this work, three cases are considered: (1) Constant input voltage into the power amplifier, (2) constant voltage across the piezoelectric transducer, and (3) constant average power dissipation in the transducer. For each case, the measured and the simulated responses are compared, and good agreement is obtained. It is shown that Case 1, the simplest and most frequently used approach, is largely affected by the impedance of the used amplifier and wiring, so it is therefore not suitable for a reproducible characterization of the intrinsic properties of the acoustofluidic device. Case 2 strongly favors resonances at frequencies yielding the lowest impedance of the piezoelectric transducer, so small details in the acoustic response at frequencies far from the transducer resonance can easily be missed. Case 3 provides the most reliable approach, revealing both the resonant frequency, where the power-efficiency is the highest, as well as other secondary resonances across the spectrum.

Acoustic Trapping: An Emerging Tool for Microfabrication Technology

“…There are some attempts to solve this problem using voltage correction or voltage compensation circuit to achieve a constant output power. [ 157 ] Further exploration in materials and electronics is needed to solve the problem of the instability of output frequency.…”

“…constant output power. [157] Further exploration in materials and electronics is needed to solve the problem of the instability of output frequency.…”