Construction and Verification of Hyperelastic Constitutive for Polymer Materials

Zhong, Cheng; Xu, Peng; Li, Chenglong; Wan, Yong-Qiang; Xue, Sen-Ming; Lu, Jibao; Liu, Zhiquan; Sun, Rong; Liu, Ning; Gao, Bin; Chang, Haijun

doi:10.1109/icept56209.2022.9872564

Cited by 1 publication

(1 citation statement)

References 10 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For this study, the Yeoh model was selected due to its widespread use in accurately predicting the behavior of hyperelastic materials. Specifically, the three‐term Yeoh model was employed for this 40,41 :

\begin{matrix} W goodbreak= \sum_{k + normall = 1}^{N} C_{kl} {({\overset{I}{true}}_{1} - 3)}^{k} {({\overset{I}{true}}_{2} - 3)}^{l} \\ newline= C_{10} ((), {\overset{true¯}{I}}_{1} goodbreak- 3) goodbreak+ C_{20} {({\overset{I}{true}}_{1} - 3)}^{2} goodbreak+ C_{30} {({\overset{I}{true}}_{1} - 3)}^{3} . \end{matrix}

…”

Section: Methodsmentioning

confidence: 99%

Large strain mechanical behaviors of optically clear adhesives for flexible electronic devices under different temperature, humidity, and strain rates

Cao,

Es'haghioskui,

Sadeghzade

et al. 2024

J of Applied Polymer Sci

View full text Add to dashboard Cite

Optically clear adhesives (OCAs), a type of polymer pressure‐sensitive adhesive, are valued for their transparency, strong bonding, thermal stability, and reliability in flexible electronics. Accurately determining the mechanical properties of OCAs is importance for effectively assessing the structural integrity of foldable screens in finite element simulations. However, previous studies have primarily focused on small strain and conventional environmental conditions. To address this gap, the present study investigates the mechanical behaviors of OCAs under extreme conditions, including large strain (up to 1000%), high/low temperatures (−40, −20, 0, 25, 65, and 80°C), and high humidity (95% relative humidity). Specifically, the tensile, simple shear, and creep properties of OCAs have been assessed in an attempt to explore their visco‐hyperelastic behavior. The experimental findings indicate that OCA exhibits noticeable temperature sensitivity and viscoelasticity, along with volume‐incompressible properties. Notably, when the temperature is varied from −40 to 25°C and from 25 to 80°C, the modulus of OCA experiences an average reduction of 84% and 41% respectively. Moreover, it has been observed that humidity has a negligible effect on the material's modulus. The Yeoh model and Prony series are employed for fitting purposes. The proposed fitting parameters are subsequently validated through numerical simulations of three‐point bending case studies. Remarkably, the simulation results closely matched with the experimental data, with errors remaining below 10%.

show abstract