2019
DOI: 10.5006/3257
|View full text |Cite
|
Sign up to set email alerts
|

Corrosion Assessment of ASME Qualified Welding Procedures for Grade 2101 Lean Duplex Stainless Steel

Abstract: ASME qualified welding procedures do not guarantee suitable corrosion and passivation properties for lean duplex stainless steel welds. An evaluation of two ASME qualified welding procedures to optimize the corrosion performance of tungsten inert gas (TIG) welded grade 2101 duplex stainless steel using ER2209 weld consumable was conducted. The evolution of the microstructure was examined by optical and electron microscopy, ferrite-scope measurements, and scanning Kelvin probe force microscopy. An electrochemic… Show more

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

2
2
0

Year Published

2019
2019
2023
2023

Publication Types

Select...
7

Relationship

0
7

Authors

Journals

citations
Cited by 14 publications
(4 citation statements)
references
References 42 publications
2
2
0
Order By: Relevance
“…A NiO peak was determined at 853.6 with a FWHM value of 1.5 eV, with the Ni(OH) 2 peak at 855.4 eV (FWHM 1.8 eV). The obtained nickel peak positions are in good agreement with literature data [38][39][40]. The exact distribution of nickel oxide and hydroxide in the layer was not determined, due to the presence of the satellite peak at 861 eV.…”
Section: Effect Of Surface Film Formationsupporting
confidence: 87%
“…A NiO peak was determined at 853.6 with a FWHM value of 1.5 eV, with the Ni(OH) 2 peak at 855.4 eV (FWHM 1.8 eV). The obtained nickel peak positions are in good agreement with literature data [38][39][40]. The exact distribution of nickel oxide and hydroxide in the layer was not determined, due to the presence of the satellite peak at 861 eV.…”
Section: Effect Of Surface Film Formationsupporting
confidence: 87%
“…Each reproved area was double-checked by field metallography performed after electrolytic etching using a 10% (w/v) oxalic acid aqueous solution to attack the microstructure. It was also observed the preferential corrosion attack of Crdepleted regions around Cr-carbides and Cr-nitrides, which promote increased DL-EPR values, corroborating the on-site DL-EPR measurements (Guilherme et al, 2019b). Figure 4 shows photomicrographs from sensitized surfaces obtained by field metallography, where the morphology of the Crdepleted zones was noticed.…”
Section: Resultssupporting
confidence: 76%
“…Cyclic potentiodynamic polarization tests were carried out to measure the passivation level integrity in view of ensure the passive film resistance at all over the surface (Guilherme et al, 2019b), and the procedure was performed in 3.5% wt. NaCl solution to evaluate the pitting corrosion resistance.…”
Section: Study Of Casementioning
confidence: 99%
“…Electrochemical tests are well established techniques employed in studies of corrosion and passivation of stainless steels [2][3][4][5][6][7] . The use of a micrometric exposed surface area enables more precise evaluation of the electrochemical behavior of stainless steel surfaces [8][9][10][11][12][13] .…”
Section: Introductionmentioning
confidence: 99%