Corrosion resistance of stainless steel coated with sol–gel silica

Vasconcelos, Daniela C.L.; Carvalho, Joelma Anastácio; Mantel, Marc; Vasconcelos, Wander L.

doi:10.1016/s0022-3093(00)00155-1

Cited by 123 publications

(76 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Unclassified

Order By: Relevance

“…The coating of metallic surfaces by sol-gel films has been proposed as a useful way to protect them from oxidation and chemical attack [10][11][12][13][14]. Izumi et al [15] reported an increase in chemical resistance of aluminized steel sheets coated with sol-gel silica and zirconia, in a 5% NaCl solution.…”

Section: Introductionmentioning

confidence: 99%

Infrared Spectroscopy of Titania Sol-Gel Coatings on 316L Stainless Steel

Vasconcelos¹,

Costa²,

Nunes³

et al. 2011

MSA

View full text Add to dashboard Cite

show abstract

Section: Introductionmentioning

confidence: 99%

Infrared Spectroscopy of Titania Sol-Gel Coatings on 316L Stainless Steel

Vasconcelos¹,

Costa²,

Nunes³

et al. 2011

MSA

View full text Add to dashboard Cite

show abstract

“…Silica coating of steel and plastic materials with silicon alkoxides, such as tetraethylorthosilicate (TEOS: Si(OC2H5)4), has been shown to improve corrosion-resistance and heatresistance of the base materials 10,11) . To obtain compact silica films with TEOS, a temperature exceeding 600˚C is required.…”

Section: Introductionmentioning

confidence: 99%

Silica film coating method for veneering resin composite

et al. 2011

View full text Add to dashboard Cite

The preceramic polymer perhydropolysilazane (PHPS) is an attractive candidate as a coating material to prevent discoloration of veneering resin composites. At the present time, however, a practical method to apply this material is not available. The purpose of this study was to establish a low-temperature method for applying a silica film coating to a veneering resin composite. Two types of PHPS, NP and NL, were coated onto a veneering resin composite. The specimens were exposed to hydrogen peroxide vapor at 97˚C, and the state of the conversion process was evaluated using FT-IR. With exposure to the hydrogen peroxide vapor, a 0.5-µm-thick silica film similar to that produced by baking was formed on the surface of the NP samples in 10 min, while a 0.2-µm-thick film was formed on the NL in 15 min. The silica coating method described in this study may mitigate the discoloration of veneering resin composite.

show abstract

“…Studies on resistance to corrosion have also been published where electrochemical measures are used on SiO 2 coatings (Vasconcelos 2000;Simoes 2000) and on ZrO 2 coatings (Quinson 1996). The analysis of the behaviour of these coatings in NaCl reveals the presence of porosity within the coatings, which allows chloride ions to diffuse up to the coating-steel interface.…”

Section: Inorganic Coatings On Different Substratesmentioning

confidence: 99%