Critical aspects of using bacterial cell viability assays with the fluorophores SYTO9 and propidium iodide

Abstract

BackgroundViability staining with SYTO9 and propidium iodide (PI) is a frequently used tool in microbiological studies. However, data generated by such routinely used method are often not critically evaluated for their accuracy. In this study we aim to investigate the critical aspects of this staining method using Staphylococcus aureus and Pseudomonas aeruginosa as the model microorganisms for high throughput studies in microtiter plates. SYTO9 or PI was added alone or consecutively together to cells and the fluorescence intensities were measured using microplate reader and confocal laser scanning microscope.ResultsWe found that staining of S. aureus cells with SYTO9 alone resulted in equal signal intensity for both live and dead cells, whereas staining of P. aeruginosa cells led to 18-fold stronger signal strength for dead cells than for live ones. After counterstaining with PI, the dead P. aeruginosa cells still exhibited stronger SYTO9 signal than the live cells. We also observed that SYTO9 signal showed strong bleaching effect and decreased dramatically over time. PI intensity of the culture increased linearly with the increase of dead cell numbers, however, the maximum intensities were rather weak compared to SYTO9 and background values. Thus, slight inaccuracy in measurement of PI signal could have significant effect on the outcome.ConclusionsWhen viability staining with SYTO9 and PI is performed, several factors need to be considered such as the bleaching effect of SYTO9, different binding affinity of SYTO9 to live and dead cells and background fluorescence.Electronic supplementary materialThe online version of this article (doi:10.1186/s12866-015-0376-x) contains supplementary material, which is available to authorized users.

N -Acetyl- l -Cysteine and Cysteamine as New Strategies against Mixed Biofilms of Nonencapsulated Streptococcus pneumoniae and Nontypeable Haemophilus influenzae

“…It should be noted that at concentrations of Ն2.5 mg/ml, most of the cells in the biofilm were stained green (data not shown), although they were nonviable, as deduced from the fact that they produced no colonies in agar plating experiments. This finding is an additional drawback to those previously reported for the BacLight viability kit (27).…”

Temporal and intrinsic factors of rifampicin tolerance in mycobacteria

“…PI is used to identify cells with disrupted membranes; these cells will take up the stain, whereupon the PI fluoresces upon intercalation with DNA (SI Appendix, Fig. S1) (18). Of 92 total cells, 81 did not grow after the drug treatment and were thus classified as susceptible.…”

Photodynamic antimicrobial chemotherapy for <em>Staphylococcus aureus</em> and multidrug-resistant bacterial burn infection in vitro and in vivo

“…ROS are produced by the photosensitive drug after light irradiation, and inflict aspecific damage to bacteria. 25,26 Much is already known about the photodynamic inactivation of microorganisms: both antibiotic-sensitive and -resistant strains can be successfully photoinactivated, and there is the additional advantage that repeated photosensitization of bacterial cells does not induce a selection of resistant strains. [27][28][29][30] In our previous study, we investigated the photodynamic activity of a new photosensitive (sinoporphyrin sodium [DVDMS]).…”

“…Viable cells are assumed to have intact and tight cell membranes that cannot be penetrated by some staining compounds, whereas dead cells are considered to have disrupted and/or broken membranes. 26,45 The combined usage of SYTO 9 and PI in a commercially available kit was first described in 1996, and it is promoted as a rapid and reliable method for assessment of bacterial viability that gives quantitative results and can be applied to microplate-reader flow-cytometry combined staining with SYTO 9 and PI.…”