Crystallization process, microstructure, thermal behavior, and magnetic properties of melt-spun Fe86Cr6P6C2 ribbons

Abadlia, L.; Daoudi, Mourad Ibrahim; Alleg, S.

doi:10.1007/s00339-023-06745-4

Cited by 1 publication

(1 citation statement)

References 58 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The structure of partially crystalline alloys consists of nanocrystals and a surrounding amorphous matrix [1][2][3]. These materials are usually obtained by the controlled crystallization of amorphous alloys [4][5][6]. Most often, a nanocrystalline structure is obtained using heat treatment, and in recent years, deformation effects on the amorphous phase have also been used for this purpose [7][8][9][10][11][12][13][14][15][16][17][18].…”

Section: Introductionmentioning

confidence: 99%

The Effect of a Coating on the Crystallization of Multicomponent Co-Based Amorphous Alloys

Abrosimova,

Chirkova,

Volkov

et al. 2024

Coatings

View full text Add to dashboard Cite

The effect of protective coatings on the crystallization of amorphous Co-based alloys was studied using the methods of X-ray diffraction, differential scanning calorimetry, and transmission electron microscopy. The crystallization of the amorphous alloys was studied on as-prepared samples, deformed samples, and deformed samples with a protective coating. After heat treatment, the fraction of the crystalline phase in the pre-deformed samples was higher than in the undeformed samples. When using a protective coating, the fraction of nanocrystals formed during heat treatment increased. The size of the crystals formed in deformed samples was smaller, and in the deformed samples with a protective coating, they were slightly larger than in the corresponding initial samples. The reasons for the differences in the formed structure in the amorphous alloys under study are discussed in terms of free volume.

show abstract