CVAR-Seg: An Automated Signal Segmentation Pipeline for Conduction Velocity and Amplitude Restitution

Abstract

BackgroundRate-varying S1S2 stimulation protocols can be used for restitution studies to characterize atrial substrate, ionic remodeling, and atrial fibrillation risk. Clinical restitution studies with numerous patients create large amounts of these data. Thus, an automated pipeline to evaluate clinically acquired S1S2 stimulation protocol data necessitates consistent, robust, reproducible, and precise evaluation of local activation times, electrogram amplitude, and conduction velocity. Here, we present the CVAR-Seg pipeline, developed focusing on three challenges: (i) No previous knowledge of the stimulation parameters is available, thus, arbitrary protocols are supported. (ii) The pipeline remains robust under different noise conditions. (iii) The pipeline supports segmentation of atrial activities in close temporal proximity to the stimulation artifact, which is challenging due to larger amplitude and slope of the stimulus compared to the atrial activity.Methods and ResultsThe S1 basic cycle length was estimated by time interval detection. Stimulation time windows were segmented by detecting synchronous peaks in different channels surpassing an amplitude threshold and identifying time intervals between detected stimuli. Elimination of the stimulation artifact by a matched filter allowed detection of local activation times in temporal proximity. A non-linear signal energy operator was used to segment periods of atrial activity. Geodesic and Euclidean inter electrode distances allowed approximation of conduction velocity. The automatic segmentation performance of the CVAR-Seg pipeline was evaluated on 37 synthetic datasets with decreasing signal-to-noise ratios. Noise was modeled by reconstructing the frequency spectrum of clinical noise. The pipeline retained a median local activation time error below a single sample (1 ms) for signal-to-noise ratios as low as 0 dB representing a high clinical noise level. As a proof of concept, the pipeline was tested on a CARTO case of a paroxysmal atrial fibrillation patient and yielded plausible restitution curves for conduction speed and amplitude.ConclusionThe proposed openly available CVAR-Seg pipeline promises fast, fully automated, robust, and accurate evaluations of atrial signals even with low signal-to-noise ratios. This is achieved by solving the proximity problem of stimulation and atrial activity to enable standardized evaluation without introducing human bias for large data sets.

A Review of Healthy and Fibrotic Myocardium Microstructure Modeling and Corresponding Intracardiac Electrograms

“…However, most in silico experiments do not consider these factors, which might alter the EGM characteristics. Simulation studies have created a model of clinical noise which covers the electromagnetic interference ( Sánchez et al, 2021a ; Nothstein et al, 2021 ). However, further aspects likely need to be considered explicitly if their influence is relevant for the intended use of the model.…”

Physics-informed neural networks to learn cardiac fiber orientation from multiple electroanatomical maps

“…In this scenario, least-squares approaches [29,30] may perform better than purely geometric methods [17,28]. Nonetheless, a careful pre-processing of the input data is always necessary, in order to avoid unrealistically fast or low CVs [17,32]. In some cases very high CVs may actually be due to physiological phenomena, as breakthroughs and front collisions where, however, the CV is not well-defined.…”

Automatické měření efektivní refrakterní periody srdeční tkáně

“…Tento protokol je standardně používán pro měření elektrofyziologických vlastností vyšetřované tkáně, a především k určení ERP. Protokol sestává z opakované stimulace tkáně s periodou S1, která je následována jedním nebo i více stimuly, s periodou S2, která bývá zpravidla kratší[4]. Počet stimulů a délka periody ve fázi S1 může být obecně různá.…”