Defining the eco‐efficiency of rubber glove products manufactured from concentrated latex in Thailand

Abstract

The aim of this research was to define the performance of rubber glove products manufactured from concentrated latex using eco‐efficiency. Data were collected from two concentrated latex and two rubber glove industries between 2009 and 2011 for the case study to define the eco‐efficiency by comparing product values and environmental impact indicators. Eco‐efficiency trends of rubber glove products manufactured using concentrated latex production were analyzed using a snapshot graph. The results indicated that the highest and lowest eco‐efficiency values of rubber glove products manufactured from concentrated latex were waste production and energy consumption, respectively. Eco‐efficiency trends of rubber glove products manufactured from concentrated latex pertaining to material consumption, energy consumption, chemical consumption, and waste production were observed as being half eco‐efficient. In addition, the hotspot of high environmental burden of rubber glove products manufactured from concentrated latex was found to be in the process of manufacture. The definition of eco‐efficiency values and trends for rubber glove products manufactured from concentrated latex mentions that energy and chemical consumptions cause dominant environmental problems. Therefore, the master approach to eco‐efficiency enhancement of rubber glove products manufactured from concentrated latex developed with the four case study industries were as follows: (1) the load factor use of electricity per month, (2) increasing measurements of reduction in energy efficiency in the office concerning concentrated latex process, and (3) the installation of the production line using latex glove processes. © 2015 American Institute of Chemical Engineers Environ Prog, 35: 802–808, 2015

Joint Benchmarking and Eco-Efficiency for the Sustainable Performance of Swine Production in Thailand

“…The eco-efficiency assessment of swine farm production was modified from key concepts of the World Business Council for Sustainable Development [8] and a previous study [13], measured using the ratio between swine production value and total environmental impact from the production process. The eco-efficiency calculation is shown in equation (1).…”

“…Firstly, indicator units were normalized before benchmarking, then the eco-efficiency value of each indicator was benchmarked to identify best practice performance. The concept of material flow analysis [13] was used to confirm the process of best practice farm in each indicator. Finally, indepth interviewing and brainstorming with farm owners were included for approach verification and then the recommended approach of swine production for sustainable management in Thailand was developed.…”

Estimation of eco‐efficiency and identification of its influencing factors in China's Yangtze River Delta urban agglomerations

“…Based on the connotations of eco‐efficiency, current studies selected indictors from these aspects, that is, economy, resource, and environment. Gross domestic product (GDP), per capita GDP, added value of industry, production capacity, and sales volume (Moutinho, Madaleno, Robaina, & Villar, 2018; Ounsaneha & Rattanapan, 2016; Zhang, Liu, Chang, & Zhang, 2017) were selected as economic indicators. Energy consumption and energy intensity, water consumption and water intensity, electricity (Camarero, Castillo, Picazo‐Tadeo, & Tamarit, 2013; Guan & Xu, 2016; Mehmeti, Todorovic, & Scardigno, 2016; Zhou et al, 2018) were selected as the indicators of resource utilization.…”

Carbon Footprints of Rubber Products Supply Chains (Fresh Latex to Rubber Glove)

“…The concentrated latex is mixed with various compounding chemicals based on need, then brought to forming process with dipping technique, which is the main production process followed by Thailand's rubber glove manufacturers (Ounsaneha and Rattanapan, 2016). In this process, a mold is dipped in a cleaning tank which has three steps as acid clean the tank to remove mold residues, water rinse the tank to remove the acid from the previous step and alkali clean the tank to dissolve proteins and fats.…”