Deflection-Based Aircraft Structural Loads Estimation With Comparison To Flight

Abstract

Traditional techniques in structural load measurement entail the correlation of a known load with strain-gage output from the individual components of a structure or machine. The use of strain gages has proved successful and is considered the standard approach for load measurement. However, remotely measuring aerodynamic loads using deflection measurement systems to determine aeroelastic deformation as a substitute to strain gages may yield lower testing costs while improving aircraft performance through reduced instrumentation weight. With a reliable strain and structural deformation measurement system this technique was examined. The objective of this study was to explore the utility of a deflection-based load estimation, using the active aeroelastic wing F/A-18 aircraft. Calibration data from ground tests performed on the aircraft were used to derive left wing-root and wing-fold bending-moment and torque load equations based on strain gages, however, for this study, point deflections were used to derive deflection-based load equations. Comparisons between the strain-gage and deflection-based methods are presented. Flight data from the phase-1 active aeroelastic wing flight program were used to validate the deflection-based load estimation method. Flight validation revealed a strong bending-moment correlation and slightly weaker torque correlation. Development of current techniques, and future studies are discussed. = measured load of sample l n = number of strain gages P l = true load of sample l PCM = pulse code modulation S i = i th strain-gage signal Nomenclature

Robust stability analysis of H∞-SGQKF and its application to transfer alignment

“…So TA performance represents the primary challenge in modeling uncertainty. Four distinctive approaches to treat the aircraft flexibilities and vibrations in TA are: determining the in-flight flexible aircraft wing motion using various measurement techniques [37], and processing the flexibilities and vibrations sensed by the inertial sensors as system noise in the filer equations [38]. The first three approaches above need extra hardware or software expenditures, the last one needs only software expenditures.…”

Realtime Localization and Estimation of Loads on Aircraft Wings from Depth Images

“…Current aircraft maintenance and repair systems used for structural monitoring rely on load monitoring systems while using strain gauges [1,2], optical measurement systems [3][4][5][6][7], and fiber brag grating (FBG) [8][9][10][11] sensors.…”

“…Afterwards, many research on wing deflection measurement and analysis were motivated by the catastrophic failure of the unmanned aerial vehicle (UAV) Helios [5,6]. Lizotte et al [7] proposed estimation of aircraft structural loads based on wing deflection measurements. Their approach is based on the installation of infrared lightemitting diodes (LEDs) on the wings; however, the deflection measurements are local, which do not cover the whole wing structure unless a large number of LEDs are installed.…”

“…Nonetheless, depth cameras can be installed on a larger aircraft with a minimum distance according to the depth sensor's operation range between the wing and the installation location. Depth cameras could be installed in place of RGB cameras that were fitted on the aircraft [3,4,7] but with the advantage of not requiring installation of additional marker's or LEDs on the wing as shown in Figure 6. The installation of the depth sensors at an angle, as shown in Figure 6, will not affect their operation, since, once a deflection occurs over the span of the wing, the wing's depth will change with respect to the pose of the installed depth sensor.…”

Deformation Measuring Methods Based on Inertial Sensors for Airborne Distributed POS

“…However, it has limitation to the aircraft material and needs many wires which will increase the load of the aircraft. Besides, the strain sensor is easily affected by the physical abrasion, temperature, and so forth [12][13][14]. As for optical measurement, the Dutch National Aerospace Laboratory (NLR) used a camera to record the black and white striped pattern on the wing surface to estimate the flexible deformation [15].…”