Densimetric Studies of Binary Solutions Involving H2O or D2O as a Solute in Dimethylsulfoxide at Temperatures from (293.15 to 328.15) K and Atmospheric Pressure

Volume-related properties of thiophene and furan-2-carboxaldehyde phenylhydrazone derivatives in DMSO: A discussion about non-intrinsic contribution

“…Before measurements, the instrument was calibrated using bi-distilled and degassed water, dry air, benzene and DMSO. The densities for benzene (0.879010 g·cm −1 ) and DMSO (1.10056 g·cm −3 ) were in good agreement with published data [23,24,25,26,27] (See Table 2). …”

Determination of density, viscosity and vapor pressures of mixtures of dimethyl sulfoxide + 1-allyl-3-methylimidazolium chloride at atmospheric pressure

“…Relative deviations for DMSO density against the temperature between the experimental density data of this work and those reported by: Campbell[31] (); Casteel et al[32] (); Wang et al[33] (); Ivanov et al[34] (); Iulian et al[35] (); Krakoviak et al[36] (); Zarei et al…”

“…Comparison of the DMSO density with literature data [31][32][33][34][35][36][37][38] is presented in Figure 3. It can be observed that our data are consistent with the data reported by others authors.…”

Determination of Density and Viscosity of Binary Mixtures of Water and Dimethyl Sulfoxide with 1-Ethyl-3-methylimidazolium Diethylphosphate [EtMeIm]+[Et2PO4]− at Atmospheric Pressure

“…The density of pure DMSO has been compared to that of others authors. Figure shows the relative deviation for data found in the literature. − Despite the high purity and low moisture of the DMSO reported in this work, some differences are observed between the literature data and this article’s data. Wang et al reported a purity of ≤99% in mass fraction.…”

“…Wang et al reported a purity of ≤99% in mass fraction. Ivanov et al reported a drying process before the experiments reaching a water content below 0.01% in mass fraction. Krakowiak et al .…”