Design and simulation of triple band GSM900/DCS1800/UMTS2100 MHz microstrip antenna for base station

Nikmehr, Saeid; Moradi, Khatereh

doi:10.1109/iccs.2010.5686358

Cited by 9 publications

(3 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…1. The antenna is composed from a single substrate layer compared to other multilayer antennas [9]. The overall antenna dimension is about 285×140×1.645 mm 3 .…”

Section: Antenna Design and Configurationmentioning

confidence: 99%

Multi band microstrip slot antenna for mobile base station

Shaker

Abdullah

allah

2012

Proceedings of the 2012 IEEE International Symposium on Antennas and Propagation

View full text Add to dashboard Cite

In this paper, a multi-band dual-polarized transceiver microstrip slot antenna with dual feed is presented. The antenna is suitable for operation in mobile phone base stations. The antenna operating bands are (0.792 -0.979) GHz, (1.74 -2.2) GHz and (2.4 -2.68) GHz. The antenna support GSM, DCS, PCS, UMTS, ISM and LTE. The proposed antenna shows good reduction in area and height by 37.46% and 92.78%, respectively compared to other one's with an isolation more than 29 dB between ports. The antenna is based upon two orthogonal cross slots etched on the metallic ground plane and incorporates a simple single layered feeding technique to achieve dual polarization radiation with an isolation more than 29 dB between them. The effort was directed towards the design of a single standalone antenna; however, the performance would be better when it is incorporated as an array element. Also, the experimental results are compared to the simulated results. Very good results are obtained.

show abstract

“…1. The antenna is composed from a single substrate layer compared to other multilayer antennas [9]. The overall antenna dimension is about 285×140×1.645 mm 3 .…”

Section: Antenna Design and Configurationmentioning

confidence: 99%

Multi band microstrip slot antenna for mobile base station

Shaker

Abdullah

allah

2012

Proceedings of the 2012 IEEE International Symposium on Antennas and Propagation

View full text Add to dashboard Cite

show abstract

“…Therefore, it is difficult for these antennas to be designed as an array. Similarly, the wideband antennas proposed in [13][14][15][16][17][18] are difficult to be arrayed. Moreover, in [19], although the proposed wideband antennas have a compact size, they have a complex structure, which leads to high cost and difficulty in postfabrication tuning.…”

Section: Introductionmentioning

confidence: 99%

Dual-Polarized Crossed Bowtie Dipole Array for Wireless Communication Applications

Zhang

Zuo

et al. 2014

International Journal of Antennas and Propagation

View full text Add to dashboard Cite

A dual-polarized array with downtilted radiation patterns is proposed for wireless communication applications. The proposed dual-polarized antenna element achieves an enhanced impedance bandwidth and compact dimensions by introducing a parasitic circular patch and vertical metal cylinders, which is a good candidate for radiating elements in base station antennas. By optimizing the amplitude and phase distribution along the feed, a radiation pattern with a downtilted angle is obtained. The dual-polarized array antenna achieves an impedance bandwidth for VSWR≤1.5, covering the frequency bands for 3G/LTE systems. Moreover, the proposed array achieves high port isolation, the stable antenna gain over the entire operating band. Therefore, the proposed array antenna is very suitable for potential wireless communication applications. A prototype has been manufactured and measured. The measurements, that match the design objectives, are also presented.

show abstract

“…In the last decade, many techniques have been reported in order to investigate dual-band dual-polarized antennas that suit the mobile base station. In [4, 5], a dual-band dual-polarized ASP antenna with double-sided notches operating at GSM900, DCS1800, and UMTS2100 band operations was introduced. The dual-band operation behavior was obtained by introducing a reactive loading where an inset or a notch is cut on the radiating patch.…”

Section: Introductionmentioning

confidence: 99%

Slot antenna for mobile base station using AMC

El-Gendy

Abdullah

Abdallah

2014

Int. J. Microw. Wireless Technol.

View full text Add to dashboard Cite

In this paper, a new configuration of dual-band, dual-polarized microstrip antenna applicable to mobile base stations is proposed. The concept behind the new design is the use of an artificial magnetic conductor (AMC) structure that operates in the required two bands beneath a radiating diamond shaped slot. The choice of the diamond-shaped slot is due to its support of an infinite number of resonant modes where the dimensions of the diamond shape have more degree of freedom that controls the excited modes when compared to the rectangular slot. The proposed antenna works over the 870–960 MHz (GSM850/GSM900) band and the 1710–2170 MHz (DCS1800/PCS1900/UMTS2100) bands for mobile communication systems. The antenna is suitable for transmitting and receiving mobile signals since it has two ports of orthogonal polarization. The antenna is fabricated on a combination of FR4 dielectric substrate and foam layers in order to achieve low cost. The proposed antenna yields high isolation between its two ports not exceeding −30 dB and a front-to-back ratio exceeding 15 dB. The average antenna gains are about 6.6 dBi at the GSM850/GSM900, 7.1 dBi at the DCS1800/PCS1900, and 6.8 dBi at the UMTS2100 bands. The theory of radiation is proved analytically and verified by comparing its results with some simulated results. Finally, a good agreement between the simulated and measured results is noticed.

show abstract

Design and simulation of triple band GSM900/DCS1800/UMTS2100 MHz microstrip antenna for base station

Cited by 9 publications

References 8 publications

Multi band microstrip slot antenna for mobile base station

Multi band microstrip slot antenna for mobile base station

Dual-Polarized Crossed Bowtie Dipole Array for Wireless Communication Applications

Slot antenna for mobile base station using AMC

Contact Info

Product

Resources

About