Design of a Monitoring System for Hydroganics based on Arduino Uno R3 to Realize Sustainable Development Goal`s number 2 Zero Hunger

Nugraha, Anggara Trisna; Priyambodo, Dadang

doi:10.35882/jeeemi.v3i1.8

Cited by 7 publications

(2 citation statements)

References 2 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Wonderful insulation (excellent insulating) [13]. Ready to extinguish arcs (arc) -Low viscosity [14]. Stable, challenging to react, good non conductor properties in SF6 due to the wide cross-sectional of the SF6 molecule and also the massive negatron affinity (Electronegativity) of the chemical element atom [15].…”

Section: Gas Sulphure Hexafluride (Sf6)mentioning

confidence: 99%

Comparison of Insulated Switch Gear with Desiccant Addition to SF6 Gas Quality System at Waru Substation

Nugraha,

Ramadhan,

Shiddiq

et al. 2023

JEEMECS

View full text Add to dashboard Cite

In electrical instrumentality with SF6 gas insulation, the quality of SF6 gas in line with the standard is prime to wise insulation power, if there' a decrease in gas quality, there'll even be a decrease among the number of voltage insulation on electrical equipment. throughout this case, it had been found that the quality of SF6 gas was deteriorating within the Ganz whole GIS Compartment at the Waru Substation Substaction, specifically the position level of the SF6 isolation gas that exceeded the required standard limit. Besides, this GIS isn't equipped with silica gel/desiccant as a condition gripping material and gas sorbent material from amendment PMT (IEEE Std 11251993) that ends throughout a decrease among the standard of SF6 gas. The addition of drier among the GIS is needed to keep up the quality of SF6 gas. These materials are analyzed for quantity and performance once applied within the compartment therefore as that deterioration of the quality of SF6 gas and thus the prevalence of insulation failure is avoided as early as possible, and SF6 remains in its characteristics with a BDV of 78.6 kV/cm (according to SF6 crucial Breakdown Volatge). And it hoped that SF6 gas will add line with it operate as a decent insulating medium. As degree application, a drier experiment has been administered among the GIS compartment at the Waru Substation station

show abstract

Section: Gas Sulphure Hexafluride (Sf6)mentioning

confidence: 99%

Comparison of Insulated Switch Gear with Desiccant Addition to SF6 Gas Quality System at Waru Substation

Nugraha,

Ramadhan,

Shiddiq

et al. 2023

JEEMECS

View full text Add to dashboard Cite

show abstract

“…Cooling fan is a component that functions to remove heat and replace it with fresh air into the interior of the room, the shape of the device is like a fan in general but is so small with dimensions of 12 cm x 12 cm [23].…”

Section: Cooling Fanmentioning

confidence: 99%

Desain and Build a Medium Voltage Cubicel Temperature and Humidity Optimization Tool to Minimize the Occurrence of Corona Disease with the PLC-Based Fuzzy Method

Sheila

Rochamwati

Riyadi

et al. 2022

Indones.J.electronic.electromed.med.inf

View full text Add to dashboard Cite

Cubicle is an electrical device that functions as a breaker, protector, connector, controller, and divider of the power system electricity from a power source and reduce sparks when connecting. One of the problems that occur in medium voltage cubicles is the presence of corona. Corona phenomena at cubicle terminations can trigger disturbances such as a decrease in insulation quality, power loss and a significant increase in harmonic distortion. Based on previous research, the solution to minimize the occurrence of corona is to optimize the temperature and humidity of the cubicle. Many of the previous studies examined the control of cubicle temperature and humidity using fans and heaters, but the temperature and humidity had not yet reached a stable and optimal point. In this study, raised a problem regarding the optimization of temperature and humidity in cubicles using the fuzzy method to stabilize the performance of medium voltage cells. In this study, it was found that the fuzzy method in this prototype was able to stabilize the panel humidity at 55% RH and stabilize the panel room temperature at 31.5 o C. Thus, it is hoped that a stable and optimal temperature and humidity can minimize the occurrence of corona. The use of HMI/SCADA based applications can facilitate the ability of the user (operator) to monitor several available parameters and manually control the operation of the panel (on/off).

show abstract

Battery Charger Design in a Renewable Energy Portable Power Plant Based on Arduino Uno R3

Nugraha

Pambudi

Utomo

et al. 2022

Proceedings of the 2nd International Conference on Electronics, Biomedical Engineering, and Health Informatics

View full text Add to dashboard Cite

Design of a Monitoring System for Hydroganics based on Arduino Uno R3 to Realize Sustainable Development Goal`s number 2 Zero Hunger

Cited by 7 publications

References 2 publications

Comparison of Insulated Switch Gear with Desiccant Addition to SF6 Gas Quality System at Waru Substation

Comparison of Insulated Switch Gear with Desiccant Addition to SF6 Gas Quality System at Waru Substation

Desain and Build a Medium Voltage Cubicel Temperature and Humidity Optimization Tool to Minimize the Occurrence of Corona Disease with the PLC-Based Fuzzy Method

Battery Charger Design in a Renewable Energy Portable Power Plant Based on Arduino Uno R3

Contact Info

Product

Resources

About