Design of novel grid-tied solar — Wind hybrid power plant using photovoltaic cell emulating system

Phap, Vu Minh; Yamamura, Naoki; Ishida, M.; Hirai, Junji; Nga, Nguyen Thuy

doi:10.1109/icset.2016.7811779

Cited by 7 publications

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The basic working principle of a power converter lies in switching and the accuracy of the values of the components. DC-DC Converter is widely applied to large systems or as sub-systems with source and output systems in the form of DC electrical networks [3]. DC-DC Converter can be applied one of them on a power generation system with a source of solar panels.…”

Section: Introductionmentioning

confidence: 99%

Evaluation and Comparison of DC-DC Power Converter Variations in Solar Panel Systems Using Maximum Power Point Tracking (MPPT) Flower Pollination Algorithm (FPA) Control

2020

View full text Add to dashboard Cite

Maximum Power Point Tracking (MPPT) is a method that can be used to optimize the electrical power output from solar panels. The performance of the MPPT method on solar panel systems can be influenced by many variables. One of them is the selection of a DC-DC power converter. DC-DC-DC Converter is a component that is used to optimize the performance of solar panels. Several types of DC-DC Converter are Buck, Buck-Boost, Single Ended Primary Inductance Converter (SEPIC), and CUK. Each converter has a different effect on solar panels output power. In order to observe and make a comprehensive analysis, simulations are performed through PSIM (Power Simulator) software on the performance of several DC-DC Converters that use Flower Pollination Algorithm (FPA) as the MPPT algorithm. Variables that observed are the output power characteristic, the response of the voltage-current ripple signal, and the accuracy of the converter in the process of reaching the maximum power point condition. As a result, CUK converter can obtain the highest value of solar panel output power, 145.02 W. A low ripple level with a stable power value response is entirely generated by CUK and SEPIC Converter. Overall, for this system, the CUK converter has better performance than the other converters.

show abstract

Section: Introductionmentioning

confidence: 99%

Evaluation and Comparison of DC-DC Power Converter Variations in Solar Panel Systems Using Maximum Power Point Tracking (MPPT) Flower Pollination Algorithm (FPA) Control

2020

View full text Add to dashboard Cite

show abstract

Study on Novel Topology of Solar–Wind Hybrid Power Plant Using Photovoltaic Cell Emulating System

Phap

Yamamura

Ishida

et al. 2019

J. Electr. Eng. Technol.

Self Cite

View full text Add to dashboard Cite

At the present, the grid-tied solar power system is the most promising as a renewable energy technology for replacing the fossil energy sources. The usage efficiency of the power conditioner system in the grid-tied solar power system is not high because the electricity generation from solar panels depends on the weather. The utilization rate of the power conditioner system can be increased by adding the small scale wind turbine to the existing grid-tied solar power system. We introduced a novel design solution in the previous study to connect the small wind turbine with the power conditioner system of the grid-tied solar power system by emulating technical characteristics of the solar panel in series connection mode. By which, the utilization rate of the power conditioner system has been increased. However, this improved utilization rate of the power conditioner system is not high in the cloudy and rainy days because the voltage of the solar panel changes slightly and the maximum input voltage of the power conditioner system is limited. Therefore, we propose a novel performance enhancement method for solar-wind hybrid power plant using photovoltaic cell emulating system in this research.

show abstract

Development of cooperating system capable of parallel connection with photovoltaic power generation system

Minakuchi

Yamamura

2022

2022 25th International Conference on Electrical Machines and Systems (ICEMS)

View full text Add to dashboard Cite

Design of novel grid-tied solar — Wind hybrid power plant using photovoltaic cell emulating system

Cited by 7 publications

References 5 publications

Evaluation and Comparison of DC-DC Power Converter Variations in Solar Panel Systems Using Maximum Power Point Tracking (MPPT) Flower Pollination Algorithm (FPA) Control

Evaluation and Comparison of DC-DC Power Converter Variations in Solar Panel Systems Using Maximum Power Point Tracking (MPPT) Flower Pollination Algorithm (FPA) Control

Study on Novel Topology of Solar–Wind Hybrid Power Plant Using Photovoltaic Cell Emulating System

Development of cooperating system capable of parallel connection with photovoltaic power generation system

Contact Info

Product

Resources

About