Detection of the Hydrophobic Surface Force in Foam Films by Measurements of the Critical Thickness of the Film Rupture

Abstract

At sufficiently high electrolyte concentrations (at suppressed electrostatic repulsion), the free foam films thin gradually, until reaching a certain critical thickness, and then they break. The value of this critical thickness is sensitive to the magnitude of the attractive surface forces acting in the film. We experimentally investigated the rupture of the films formed from aqueous solutions of sodium dodecyl sulfate (SDS) in the presence of 0.3 M NaCl added. The theoretical fits of the data indicate that the van der Waals interaction, alone, is insufficient to explain the measured critical thickness, especially for the lower SDS concentrations. If the difference is attributed to the hydrophobic attraction, then a very good agreement between the theory and experiment is achieved. From the best fit, we determine that the decay length of the hydrophobic force is about 15.8 nm, which coincides with the value obtained by other authors for hydrophobized mica surfaces. The strength of the hydrophobic interaction increases with the decrease of the SDS concentration, which can be explained with the fact that between the adsorbed surfactant molecules greater areas of bare hydrophobic air-water interface are uncovered. In the investigated concentration range, the strength of the hydrophobic force is found to be inversely proportional to the surface density of the adsorbed ions.

Establishment of the Center for Advanced Separation Technologies

“…At a certain salt concentration, the hydrophobic force decreases with increase in surfactant concentration, consistent with previous work (Yoon and Aksoy, 1999;Angarska, et al, 2004). …”

Drainage and stability of foam films during bubble coalescence in aqueous salt solutions

“…Interestingly, the predicted decay lengths of hydrophobic attractions in each salt solution are close to 15.78 nm. This decay length is very close to λ=15.8 nm predicted for the water film between two hydrophobized mica surfaces (Eriksson et al, 1989) and solutions of sodium dodecyl sulfate (SDS) in the presence of 0.3 M NaCl between two bubbles (Angarska et al, 2004). Indeed, λ is expected to be the same for all hydrophobic surfaces under identical solution conditions since it is a bulk property and characterizes the propagation of the hydrogen-bond ordering effect on water molecular structure between the film surfaces (Eriksson et al, 1989).…”

Establishment of the Center for Advanced Separation Technologies

“…It has also been shown that Eq. [12] can be used even at low surfactant concentrations (Ivanov et al, 2005;Angarska et al, 2004). (Wang and Yoon, 2005).…”

“…A positive pressure stabilizes the foam, while negative pressure destabilizes it. In general, the positive disjoining pressure arises from repulsive double-layer force, while the negative pressure arises from attractive van der Waals forces and possibly from hydrophobic force (Tchaliovska et al, 1994;Angarska et al, 2004).…”