Development and application of a smart grid test bench

Moreno-Garcia, Isabel M.; Moreno-Munoz, A.; Pallares-Lopez, Victor; Gonzalez-Redondo, Miguel; García, Emilio José; Moreno-Moreno, Carlos D.

doi:10.1016/j.jclepro.2017.06.001

Cited by 14 publications

(6 citation statements)

References 29 publications

(29 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The PQ analyzer is designed as per the standard specified by international electrotechnical commission (Moreno-Garcia et al, 2017) to detect the PQ disturbances. The PQ events such as voltage sag, in-rush current, voltage distortion, unbalances, flicker and interruptions are determined and demonstrated successfully.…”

Section: Measurement Of Pq Issues In 11kv/440v Distribution Feedermentioning

confidence: 99%

Real time assessment of power quality issues in 11 kV/440 V distribution feeder using distribution static synchronous compensator

Srinivasan¹,

Krishnamoorthy

Pongiannan

et al. 2020

Transactions of the Institute of Measurement and Control

View full text Add to dashboard Cite

The effects of power quality (PQ) issues in a distribution feeder occur due to abnormal load condition. In this paper, first, the real time PQ issues in an 11 kV/440 V distribution feeder are measured and analyzed by PQ analyzers. The sudden load fluctuations in the distribution system result in different PQ issues such as voltage sag/swell, transient, flicker and harmonics. Then, an improved interactive distribution static synchronous compensator (D-STATCOM) is installed in distribution feeder to mitigate the PQ issues. A novel control algorithm will operate the interactive D-STATCOM in voltage control mode (VCM) or current control mode (CCM). At normal operating conditions, the D-STATCOM operates in CCM, during abnormal condition the D-STATCOM will operates in VCM to mitigates the PQ issues. The D-STATCOM is modeled and simulated in MATLAB-SIMULINK environment. The field programmable gate array (FPGA)-based laboratory prototype D-STATCOM has been developed to validate the function of the controller.

show abstract

Section: Measurement Of Pq Issues In 11kv/440v Distribution Feedermentioning

confidence: 99%

Real time assessment of power quality issues in 11 kV/440 V distribution feeder using distribution static synchronous compensator

Srinivasan¹,

Krishnamoorthy

Pongiannan

et al. 2020

Transactions of the Institute of Measurement and Control

View full text Add to dashboard Cite

show abstract

“…The stored energy is also limited by the operative range that is expressed in (2). In this equation, E Bmin is the depth of discharge and E Bmax is the charging threshold.…”

Section: Battery Storagementioning

confidence: 99%

“…Nevertheless, the variability and uncertainty associated with these types of sources prevent them from taking part in the electricity market, due to their low dispatchability and the perturbations that they might cause in the grid [2]. Therefore, the effective management of these resources is one of the current challenges, usually solved by means of electrical storage systems [3].…”

Section: Introductionmentioning

confidence: 99%

PV Hosting Capacity Analysis and Enhancement Using High Resolution Stochastic Modeling

et al. 2017

View full text Add to dashboard Cite

Reduction of CO 2 emissions is a main target in the future smart grid. This goal is boosting the installation of renewable energy resources (RES), as well as a major consumer engagement that seeks for a more efficient utilization of these resources toward the figure of 'prosumers'. Nevertheless, these resources present an intermittent nature, which requires the presence of an energy storage system and an energy management system (EMS) to ensure an uninterrupted power supply. Moreover, network-related issues might arise due to the increasing power of renewable resources installed in the grid, the storage systems also being capable of contributing to the network stability. However, to assess these future scenarios and test the control strategies, a simulation system is needed. The aim of this paper is to analyze the interaction between residential consumers with high penetration of PV generation and distributed storage and the grid by means of a high temporal resolution simulation scenario based on a stochastic residential load model and PV production records. Results of the model are presented for different PV power rates and storage capacities, as well as a two-level charging strategy as a mechanism for increasing the hosting capacity (HC) of the network.

show abstract

“…Others reported the need of enhancing the logical node support to enable advanced power quality applications [7], but there is a lack of research exploiting the IEC 61850 PQ capabilities towards their implementation on real PQ monitoring platforms. The use of laboratory testing platforms in the last years is also limited, with some approximations in the field of real-time grid perturbation detection [8] but again incomplete from the point of view of PQ observability.…”

Section: Introductionmentioning

confidence: 99%

An IEC 61850 Sampled Values-based Analyzer for Power Quality applications on Smart Substations

Oliván

Mareca

Bruna

et al. 2021

2021 IEEE 11th International Workshop on Applied Measurements for Power Systems (AMPS)

View full text Add to dashboard Cite

Development and application of a smart grid test bench

Cited by 14 publications

References 29 publications

Real time assessment of power quality issues in 11 kV/440 V distribution feeder using distribution static synchronous compensator

Real time assessment of power quality issues in 11 kV/440 V distribution feeder using distribution static synchronous compensator

PV Hosting Capacity Analysis and Enhancement Using High Resolution Stochastic Modeling

An IEC 61850 Sampled Values-based Analyzer for Power Quality applications on Smart Substations

Contact Info

Product

Resources

About