Development of free water knock-out tank by using internal heat exchanger for heavy crude oil

Abstract

Reactivation of an old oil well can be explicitly calculated to maximize crude oil production. The biggest challenge with the activation process is the crude oil content in old wells, which is not feasible to meet the specified minimum standards. In the case of the Bunian oil field, Indonesia, the crude oil produced has high water content. It causes a decrease in the quality of production and also hinders production capacity. The production scheme applied to the Bunian field has a storage tank that functions to reduce water content using the gravity method, but this is less effective. Let’s modify the storage tank into a heat exchanger tank through the engineering design process and labeled it as a free water knockout tank (FWKO). The FWKO is made of a multi-pass tube heat exchanger. The experiments are conducted through three phases’ tests before deciding the final design. From the test, the change in water content is varied with temperature differences of the working fluid and crude oil. The lowest water content is obtained at 0.5 % at final tests. After analyzing the characteristic of each test result, the final design is taken by adjusting the suitable working fluid temperature and pressure. Finally, by using suitable parameters, the average water content of crude oil is decreased up to the minimum requirement (<0.1 %). The design of FWKO is considered simple with an excellent performance and can adapted easily. The FWKO able to process crude oil with water content <20 %, where it suitable for waxy oil well. The working fluid can be processed both in liquid and gas state. Furthermore, the heating source for the working fluid is gained from the gas flare by using thermic heater. Thus, it does not require an extra heating source for the heat exchanger

Application of Fatty Acids Distillation Products as a Substitute for Heavy Fuel Oil in Stationary Combustion Chambers

“…At a temperature of 293K and pressure of 0.1 MPa, the heat capacity of diesel is 1.9 kJ/kgK [38,39]. The average specific heat of crude oil is in a similar range of 2.2 kJ/kgK [40]. The properties of micro wax were taken from [22,41,42] (heat capacity [41,42] c p at a level of 2.5 kJ/kgK).…”

Advanced design of a small-scale mini gerotor pump in a high-temperature and high-viscosity fluid thermal system

“…An example of the application of this innovation is technological development based on the utilization of renewable energy and an increase in the scope of technological applications, which were originally centralized to become modular [1]. The application of technologies used to reactivate old oil well systems [2] and improved wind turbine models [3] are examples of innovations supporting energy supply. Furthermore, this development encourages small-scale renewable energy and creative technologies that utilize alternative fuels, such as biomass and thermal energy storage, which require special adjustments to be accepted by society [4].…”

Analysis of the thermal characteristics of the paraffin wax/high-density polyethylene (HDPE) composite as a form-stable phase change material (FSPCM) for thermal energy storage

“…The exploration of new fossil fuel sources is accompanied by the massive utilization of alternative fuels and renewable energy. This can be done by installing a heat exchanger for the dewatering process reducing the water content to less than <0.1 % [1]. Another effort can also be made by improving the system's efficiency supporting renewable energy technology as a serious effort for the transition to low-carbon power systems significantly reducing greenhouse gas emissions where a critical aspect is the feasibility [2] of the components and dispatchability of the system.…”