Diffusion Bonding of Al7075 to Ti-6Al-4V by Spark Plasma Sintering and Using a Copper Interlayer

Abstract

Sheets of aluminum 7075 and titanium Ti-6Al-4V alloys were successfully joined using the spark plasma sintering (SPS) process. A copper foil was placed as an interlayer between the two surfaces. The bonding was made at 480 °C, 500 °C, and 520 °C with a holding time of 10 min and under a uniaxial pressure of 5 MPa and 10 MPa. The obtained bonds were analyzed by scanning electron microscopy, energy dispersive spectroscopy (SEM/EDS), and wavelength dispersive spectroscopy (WDS). It was found that copper diffused away through Al7075 and formed Al2Cu intermetallics but was not present at the joint region. The investigation of the fractured surfaces using X-ray diffraction (XRD) showed that the joint region contained TiAl3, TiAl2, and Ti3Al intermetallic compounds. The presence of the Cu foil was believed to hinder the formation of Al3Ti observed in previous studies by allowing more Ti to diffuse into the Al side.

C.P titanium/Ti–6Al–4V joint by spark plasma welding: Microstructure and mechanical properties

“…where they are absorbed. Thus, the contraction of pores is associated with the migration from the center of the gravity of the grains towards the boundary plane [ [37] , [38] , [39] , [40] ].…”