Directional Solidification of Al–Si–Ti Irregular Ternary Eutectic Alloy and Thermophysical Properties

Bayram, Ümit

doi:10.1007/s11663-022-02648-6

Cited by 3 publications

(1 citation statement)

References 74 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The findings from the calculations and prior studies [29,30,[46][47][48] are included in table 3. The sharp peaks in the DTA-Temperature graph seen in figure 8 indicate the eutectic melting point (T m ).…”

Section: Effect Of Heat Treatment On Hardnessmentioning

confidence: 99%

Effect of heat treatment on microstructure of near-eutectic Al-Ni-Mn alloy, and determination of mechanical and thermoelectrical properties

Kaygısız

2024

Mater. Res. Express

View full text Add to dashboard Cite

This study examined the impact of solution heat treatment on the microstructure, mechanical characteristics, thermophysical properties, and electrical resistivity of an Al-Ni-Mn near-eutectic alloy. The investigation focused on varying temperatures and holding periods. The composition of the Al-Ni-Mn near-eutectic alloy system was chosen as Al-5.3%Ni-1.0%Mn (wt). In the non-heat-treated sample, the matrix phase (-Al) is in equilibrium with the intermetallic Al9(Mn,Ni)2 and Al3Ni phases. The hardness value of the non-heat-treated sample (49.8 kg/mm2) increased to 70.1 kg/mm2 with 2 hours of solution heat treatment at 570oC and then 8 hours of artificial aging at 180oC. The hardness value increased by approximately 41%. TE: 651.81oC for the non-heat-treated sample and TE:648.79oC for the heat-treated sample. Fusion enthalpy (H) value was determined as 336.79 (J/g) for the non-heat-treated sample and 516.36 (J/g) for the heat-treated sample. Heat Capacity (Cpl) value was found to be 0.364 J/g.K for the non-heat-treated sample and 0.560 J/g.K for the heat-treated sample. The electrical resistivity value of the 2 hours’ solution heat-treated sample at 600oC reached its highest value.

show abstract