Documentation of a Conduit Flow Process (CFP) for MODFLOW-2005

Shoemaker, W. Barclay; Kuniansky, Eve L.; Birk, Steffen; Bauer, Sebastian; Swain, Eric D.

doi:10.3133/tm6a24

Cited by 148 publications

(191 citation statements)

References 36 publications

Supporting

Mentioning

191

Contrasting

Order By: Relevance

“…This section introduces the concept of conduit-associated drainable storage and implementation of this concept within the numerical discrete-continuum model CFPM1 (Shoemaker et al, 2008). Further explanation is given about the implementation of a flow constrained boundary condition in CFPM1.…”

Section: Modeling Approachmentioning

confidence: 99%

“…Detailed explanation about the discrete pipe model is given by Shoemaker et al (2008). Following, a short overview is provided.…”

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

“…presented a discrete-continuum model for the simulation of laminar and turbulent pipe flow coupled to a continuum that represents the matrix. This approach was further developed as Conduit Flow Process Mode 1 (CFPM1) for MODFLOW-2005(Shoemaker et al, 2008. This discretecontinuum model approach was applied in a number of modeling studies presented in scientific literature (e.g., Liedl et al, 2003;Bauer et al, 2003;Hill et al, 2010).…”

Section: T Reimann Et Al: Representation Of Water Abstractionmentioning

confidence: 99%

“…where Q ip is discharge from pipe i (up to n pipes) [L 3 (Shoemaker et al, 2008). Turbulent pipe flow is considered by the Darcy-Weisbach equation with the friction factor according to the Colebrook-White equation (Shoemaker et al, 2008):…”

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

“…Turbulent pipe flow is considered by the Darcy-Weisbach equation with the friction factor according to the Colebrook-White equation (Shoemaker et al, 2008):…”

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

See 4 more Smart Citations

Representation of water abstraction from a karst conduit with numerical discrete-continuum models

Reimann

Giese²,

Geyer³

et al. 2014

Hydrol. Earth Syst. Sci.

View full text Add to dashboard Cite

Abstract. Karst aquifers are characterized by highly conductive conduit flow paths embedded in a less conductive fissured and fractured matrix, resulting in strong permeability contrasts with structured heterogeneity and anisotropy. Groundwater storage occurs predominantly in the fissured matrix. Hence, most mathematical karst models assume quasi-steady-state flow in conduits neglecting conduitassociated drainable storage (CADS). The concept of CADS considers storage volumes, where karst water is not part of the active flow system but hydraulically connected to conduits (for example karstic voids and large fractures). The disregard of conduit storage can be inappropriate when direct water abstraction from karst conduits occurs, e.g., largescale pumping. In such cases, CADS may be relevant. Furthermore, the typical fixed-head boundary condition at the karst outlet can be inadequate for water abstraction scenarios because unhampered water inflow is possible.The objective of this work is to analyze the significance of CADS and flow-limited boundary conditions on the hydraulic behavior of karst aquifers in water abstraction scenarios. To this end, the numerical discrete-continuum model MODFLOW-2005 Conduit Flow Process Mode 1 (CFPM1) is enhanced to account for CADS. Additionally, a fixed-head limited-flow (FHLQ) boundary condition is added that limits inflow from constant head boundaries to a user-defined threshold. The effects and the proper functioning of these modifications are demonstrated by simplified model studies. Both enhancements, CADS and FHLQ boundary, are shown to be useful for water abstraction scenarios within karst aquifers. An idealized representation of a large-scale pumping test in a karst conduit is used to demonstrate that the enhanced CFPM1 is able to adequately represent water abstraction processes in both the conduits and the matrix of real karst systems, as illustrated by its application to the Cent Fonts karst system.

show abstract

Section: Modeling Approachmentioning

confidence: 99%

“…Detailed explanation about the discrete pipe model is given by Shoemaker et al (2008). Following, a short overview is provided.…”

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

Section: T Reimann Et Al: Representation Of Water Abstractionmentioning

confidence: 99%

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

“…Turbulent pipe flow is considered by the Darcy-Weisbach equation with the friction factor according to the Colebrook-White equation (Shoemaker et al, 2008):…”

Section: Technical Implementation Into Modflow-2005mentioning

confidence: 99%

See 3 more Smart Citations

Representation of water abstraction from a karst conduit with numerical discrete-continuum models

Reimann

Giese²,

Geyer³

et al. 2014

Hydrol. Earth Syst. Sci.

View full text Add to dashboard Cite

show abstract

Karst water resources in a changing world: Review of hydrological modeling approaches

et al. 2014

View full text Add to dashboard Cite

Karst regions represent 7–12% of the Earth's continental area, and about one quarter of the global population is completely or partially dependent on drinking water from karst aquifers. Climate simulations project a strong increase in temperature and a decrease of precipitation in many karst regions in the world over the next decades. Despite this potentially bleak future, few studies specifically quantify the impact of climate change on karst water resources. This review provides an introduction to karst, its evolution, and its particular hydrological processes. We explore different conceptual models of karst systems and how they can be translated into numerical models of varying complexity and therefore varying data requirements and depths of process representation. We discuss limitations of current karst models and show that at the present state, we face a challenge in terms of data availability and information content of the available data. We conclude by providing new research directions to develop and evaluate better prediction models to address the most challenging problems of karst water resources management, including opportunities for data collection and for karst model applications at so far unprecedented scales.

show abstract

Intrawellbore kinematic and frictional losses in a horizontal well in a bounded confined aquifer

Wang

Zhan

2017

Water Resources Research

View full text Add to dashboard Cite

Horizontal drilling has become an appealing technology for water resource exploration or aquifer remediation in recent decades, due to decreasing operational cost and many technical advantages over vertical wells. However, many previous studies on flow into horizontal wells were based on the Uniform Flux Boundary Condition (UFBC), which does not reflect the physical processes of flow inside the well accurately. In this study, we investigated transient flow into a horizontal well in an anisotropic confined aquifer laterally bounded by two constant-head boundaries. Three types of boundary conditions were employed to treat the horizontal well, including UFBC, Uniform-Head Boundary Condition (UHBC), and Mixed-Type Boundary Condition (MTBC). The MTBC model considered both kinematic and frictional effects inside the horizontal well, in which the kinematic effect referred to the accelerational and fluid-inflow effects. A new solution of UFBC was derived by superimposing the point sink/source solutions along the axis of a horizontal well with a uniform flux distribution. New solutions of UHBC and MTBC were obtained by a hybrid analytical-numerical method, and an iterative method was proposed to determine the well discretization required for achieving sufficiently accurate results. This study showed that the differences among the UFBC, UHBC, and MTBC solutions were obvious near the well screen, decreased with distance from the well, and became negligible near the constant-head boundary. The relationship between the flow rate and the drawdown was nonlinear for the MTBC solution, while it was linear for the UFBC and UHBC solutions.

show abstract

Documentation of a Conduit Flow Process (CFP) for MODFLOW-2005

Cited by 148 publications

References 36 publications

Representation of water abstraction from a karst conduit with numerical discrete-continuum models

Representation of water abstraction from a karst conduit with numerical discrete-continuum models

Karst water resources in a changing world: Review of hydrological modeling approaches

Intrawellbore kinematic and frictional losses in a horizontal well in a bounded confined aquifer

Contact Info

Product

Resources

About