Drying Shrinkage and Elongational Properties of Bleached Softwood Kraft Handmade Sheet

Kimura, Minoru; Uchimura, Hiromi; Satoh, Keiichi; Sawatari, Atsushi

doi:10.2115/fiber.55.34

Cited by 2 publications

(2 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It was proved in a previous report [ 18] that there is no dimensional change in the handmade sheet dried on the metal plate, and that the dried-in shrinkage introduced into the partially restrained sheet is extended quantitatively in the elongation test. The fiber-oriented sheet having no drying shrinkage is able to be prepared by adoption of this fully restrained drying method.…”

Section: Introductionmentioning

confidence: 92%

“…Consequently, variation of strain-to-failure over CD of the machine-made paper is also discussed. Since a generation pattern of acoustic emission (AE) in the elongation test gives some useful information on failure mechanism of the fiber network [20,21], AE measurement is also applied to the elongation test of the machine-made paper In a previous report [18] …”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Load-Elongation Behavior of Fiber-Oriented Manila Hemp Sheets.

et al. 1999

Self Cite

View full text Add to dashboard Cite

Abstract:Fully restrained fiber-oriented sheets, machine-made paper, and handmade sheet by the standard method were prepared from Manila hemp pulp. Strain-to-failure of the fiber-oriented sheets was almost the same in both the machine (MD) and the cross machine (CD) directions, while a distinct direction-dependence was observed in the machine-made paper. This indicates that a degree of fiber orientation of paper is not a dominant factor controlling strain at break. Furthermore, dried-in shrinkage in CD of the machine-made paper can be simply estimated by comparison of strain-to-failure of this paper with that of the fully restrained fiber-oriented sheet or the handmade sheet prepared. Uneven profile of strain-to-failure in CD of the machine-made paper is observed over the width direction. This profile may possibly be explained by analogy of the geometrical and mechanical conditions of the wet web at the dryer pocket with those of the short span thin body. Notable acoustic emission (AE) from the specimens sampled from both edge and center of the dried web in the elongation test was not observed except at the final stage of plastic region. The result indicates that difference of strain-to-failure between them is attributed to a different degree of dried-in shrinkage since structural breakage like bond failure or fiber breakage which may happen in plastic deformation causes emission of elastic wave.

show abstract

Section: Introductionmentioning

confidence: 92%