Dynamic Recovery and Recrystallization Behaviors of C71500 Copper-Nickel Alloy Under Hot Deformation

Gao, Xuexu; Wu, Huibin; Liu, Ming; Zhang, Yuanxiang; Zhou, Xiangdong

doi:10.1007/s11665-020-05221-x

Cited by 12 publications

(2 citation statements)

References 28 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In order to ensure the original structure of the material, all samples were directly cut from the alloy pipe. The as-revived microstructure of the alloy was a single-phase, and a large number of low coincidence site lattice (CSL) grain boundaries could be obtained after thermomechanical treatment [ 13 , 14 , 15 , 16 , 17 ].…”

Section: Methodsmentioning

confidence: 99%

“…Our group [ 13 , 14 , 15 , 16 , 17 ] has previously studied the grain boundary engineering treatment on the mechanical behavior of C71500 copper-nickel alloy. Using the process of “multi pass deformation and grain boundary treatment + single pass deformation recovery” could obtain a large number of low coincidence site lattice grain boundary structures.…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Corrosion Behavior of High-Strength C71500 Copper-Nickel Alloy in Simulated Seawater with High Concentration of Sulfide

Gao

Liu

2022

Materials

Self Cite

View full text Add to dashboard Cite

The corrosion behavior of high-strength C71500 copper-nickel alloy in high concentrations of sulfide-polluted seawater was studied by potentiodynamic polarization measurements, electrochemical impedance spectroscopy (EIS), immersion testing, and combined with SEM, EDS, XPS, and XRD surface analysis methods. The results showed that the C71500 alloy shows activation polarization during the entire corrosion process, the corrosion rate is much higher (0.15 mm/a) at the initial stage of immersion, and the appearance of diffusion limitation by corrosion product formation was in line with the appearance of a Warburg element in the EIS fitting after 24 h of immersion. As the corrosion process progressed, the formed dark-brown corrosion product film had a certain protective effect preventing the alloy from corrosion, and the corrosion rate gradually decreased. After 168 h of immersion, the corrosion rate stabilized at about 0.09 mm/a. The alloy was uniformly corroded, and the corrosion products were mainly composed of Cu2S, CuS, Cu2(OH)3Cl, Mn2O3, Mn2O, MnS2, FeO(OH), etc. The content of Cu2S gradually increased with the extension of immersion time. The addition of S2− caused a large amount of dissolution of Fe and Ni, and prevented the simultaneous formation of a more protective Cu2O film, which promoted the corrosion process to some extent.

show abstract