Dynamical simulation of PV/Wind hybrid energy conversion system

Bakić, Vukman; Pezo, Lato; Stevanovic, Z Zana; Živković, Marija; Grubor, Borislav

doi:10.1016/j.energy.2011.11.063

Cited by 43 publications

(20 citation statements)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Baki c et al [18] developed a dynamical analysis based on the transient system simulation program TRNSYS 16 for a hybrid PV/Wind/Diesel system. Their objective was to design a realistic energy system that maximizes the use of renewable energy (solar and wind) and minimizes the use of fossil fuels.…”

Section: Introductionmentioning

confidence: 99%

Modeling and optimization of batteryless hybrid PV (photovoltaic)/Diesel systems for off-grid applications

Tsuanyo

Azoumah

Aussel

et al. 2015

Energy

View full text Add to dashboard Cite

Section: Introductionmentioning

confidence: 99%

Modeling and optimization of batteryless hybrid PV (photovoltaic)/Diesel systems for off-grid applications

Tsuanyo

Azoumah

Aussel

et al. 2015

Energy

View full text Add to dashboard Cite

“…Bakić et al [13] proposed a TRNSYS design to simulate a hybrid PV wind configuration, and they presented a dynamic simulation of solar and wind potential in Belgrade city, moreover, they presented a long-term electrical production for a specific hybrid PV wind configuration and the estimation of CO 2 reduction. As a result, HS represents a promising means of clean energy generation [14].…”

Section: Introductionmentioning

confidence: 99%

Techno-economic investigation of solar-wind potential to power an industrial prototype using a hybrid renewable energy system

et al. 2019

View full text Add to dashboard Cite

Hybridization of solar and wind energy to supply an electrical load demand is considered as a realistic approach aiming to take the benefit of these power generation sources and facilitate their integration for a stand-alone and grid-connected application. However, an under-sizing of the hybrid system mays disturbs the operation of all-electric equipment; on the contrary, an over-sizing may turn higher the investment cost of the hybrid system. Therefore an appropriate size of the hybrid renewable plant could help to guarantee the minimal cost of integration with the maximum power reliability. A specific design under TRNSYS and Matlab has been used to assess weather condition of solar irradiation, wind speed, and temperature for the selected referee cities, after, a determined load demand profile of a laboratory prototype is used to describe daily energy consumption. Then a dynamic simulation of energy output performance for different hybrid configuration is analyzed during one year; as a result, only one optimized configuration is chosen for each referee cities with respect of minimal investment cost and maximal power reliability. Finally, a techno-economic investigation of the chosen optimized solution is presented as a result and discussed, as well as an environmental assessment. Keywords Hybrid renewable energy sources (HRES) • Photovoltaic (PV) • Wind turbine (WT) • Hybrid system (HS) • Typical meteorological year (TMY2) • Economic and environmental assessment (EEA)

show abstract

“…Though their first investment costs are high, they do not have any maintenance costs. The battery capacities are expressed in kWh that is the multiple of Ah and nominal voltages [23][24][25].…”

Section: Battery-supported Wind-solar Hybrid Power Generation Sysmentioning

confidence: 99%

Simulation and Power Flow Control Using Switching’s Method of Isolated Wind-Solar Hybrid Power Generation System with Battery Storage

Oguz¹,

Çimen²,

Oğuz³

2017

Balkan Journal of Electrical and Computer Engineering

View full text Add to dashboard Cite

Abstract-In this paper, a battery-supported hybrid windsolar energy generation system with switching power flow control is presented to supply stable electrical power to two laboratories at the Electric & Electronic Engineering Department. For this purpose, 600W 3-phase permanent magnet synchronous generator (PMSG) based on the wind power generation system (WPGS) and the solar power generation system (SPGS) consisting of 190W 3 pieces mono crystal solar panel were combined to build a 1170W hybrid wind-solar power generation system (HWSPGS). The solar and wind power generation systems were used as the main energy sources while 100 Ah 12V 6 pieces gel jeep cycle accumulator groups were used as the energy storage device to ensure continuity of energy. Also dynamic modeling and switching power flow control of the battery supported the HWSPGS were performed using Matlab/Simulink in this study. Determining the switching positions of the charge control unit according to loading and battery charge situations of the HWSPGS, power flow control between the generation unit and consumer was made in planned manner. When the curves of electrical magnitudes obtained from simulation results were examined, it was determined that no big difference existed in electrical and mechanical magnitudes in parallel to dynamic behavior of the installed hybrid power generation system. Index Terms-Wind power generation, solar power generation, hybrid power generation, battery storage, switching power flow control.

show abstract

Dynamical simulation of PV/Wind hybrid energy conversion system

Cited by 43 publications

References 9 publications

Modeling and optimization of batteryless hybrid PV (photovoltaic)/Diesel systems for off-grid applications

Modeling and optimization of batteryless hybrid PV (photovoltaic)/Diesel systems for off-grid applications

Techno-economic investigation of solar-wind potential to power an industrial prototype using a hybrid renewable energy system

Simulation and Power Flow Control Using Switching’s Method of Isolated Wind-Solar Hybrid Power Generation System with Battery Storage

Contact Info

Product

Resources

About