Fissure sealants are recommended to be applied soon after the tooth eruption, mainly at the level of the first permanent molars. The additional benefits of the application of bioactive fissure sealant materials lies in the build-in functionality of these materials to chemical attack in oral cavity as well as additional antibacterial action.
IntroductionIt has been more than 40 years since the pit and fissure sealants were first used clinically. During this time, pit and fissure sealants have been shown to be effective in reducing the risk of occlusal caries, [2] and their success largely depends on the long term retention and tight micromechanical adhesion to enamel surfaces [3]. Resin based sealants can be classified as
AbstractBackground: It has been more than 40 years since the pit and fissure sealants were first used clinically. During this time, pit and fissure sealants have been shown to be effective in reducing the risk of occlusal caries.
Aim:The aim of the investigation is to further develop and evaluate a versatile designed chitosan based bio-active materials on for use as bonding free fissure sealant/fissure protectors on permanent dentition and evaluate remineralization/ demineralization capacity of the materials through pH cycling, as well as shear bond strength etch and no etch prototype as well as measurement of Vickers hardness of the newly designed materials and compare the property with the commercially available standard.
Results:In general there was an increase in bond strength of the enamel treated with the modified Premise containing nanodiamond: chitosan materials compared to the bond strength of the conventionally bonded teeth. It is seen that release of phosphorus into the dematerializing solution (i.e. loss of phosphorus from the samples) showed larger amplitude (from 600.2mg to 101.3 mg) than the uptake of phosphorus by the samples from the re-mineralizing solution (from 125.2 mg to 66.1 mg). Therefore, the treatment with chitosan seems to act more on the demineralization of tooth enamel with little effect on the remineralization process. Regarding the net phosphorus loss (net P loss), it can be seen that net demineralization occurs in all cases. However, the net amount of phosphorous released by the control group samples was significantly higher than those groups treated with chitosan. The net P loss for the control group was 475 mg of P, whereas the groups containing chitosan had a net P loss in the range of 30-182 mg. When a 1mm layer is assessed all the materials including the Premise control indicated a conversion of above 96%, which is the upper limit of the conventional fissure sealant material which makes the newly designed bioactive materials suitable for the application as fissure sealant materials. The important aspect of any newly designed/ developed restorative material is cytotoxicity as Grobler et. al [1] investigated the cytotoxic effect of nanodiamonds and also the effect of the incorporation in a dental material (Premise), who found a higher shear bond strength (p < ...
