Effect of He-irradiation fluence on the size-dependent hardening and deformation of nanostructured Mo/Zr multilayers

Wu, Shihao; Cheng, P.M.; Wu, Kai; Hou, Zhaoqi; Wang, Y.Q.; Liang, Xiaoqing; Li, J.; Kuang, J.; Liu, G.; Sun, Jun

doi:10.1016/j.ijplas.2018.07.008

Cited by 31 publications

(9 citation statements)

References 83 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…For Cu/Fe multilayer films under 6 × 10 20 ions/m 2 He irradiation with a layer thickness f less than 5 nm, the density of He bubbles increases with the decrease in layer thickness. This [92], Cu/V [5], Cu/Fe [56], Cu/Co [76], Cu/Zr [84], and Fe/W [3]; and Al/Nb [57] multilayer films after He irradiation with different fluences.…”

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 85%

“…As mentioned above, reducing the layer thickness can effectively decrease the density of irradiation-induced defects, which is responsible for the suppression of amorphization. This phenomenon exists in many multilayer films, such as Cu/Fe [56], Cu/Co [76], Cu/Zr [84], and Mo/Zr [92]. Figure 10a shows the XRD patterns of Cu/Co multilayer films with different layer thicknesses before and after irradiation [76].…”

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

“…There is a clear trend of the peak density of He bubbles decreasing with decreasing layer thickness due to the increased interface density. [92], Cu/V [5], Cu/Fe [56], Cu/Co [76], Cu/Zr [84], and Fe/W [3]; and Al/Nb [57] multilayer films after He irradiation with different fluences.…”

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

“…For multilayer films, the mechanisms of irradiation hardening are distinguished at different layer thicknesses [97]. When the layer thickness of the multilayer films is 5-150 nm, the mechanism of hardening caused by decreasing layer thickness corresponds to the confined layer slip (CLS) model [84,92,124]. Under this circumstance, the gas bubbles in the layers act as barriers to sliding dislocations, leading to irradiation-induced hardening [61,125,126].…”

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

“…For most multilayer films, such as Cu/Mo [129], Cu/V [5], Cu/Zr [84], Ag/Ni [110], Ag/V [130], Mo/Zr [92], and Fe/W [3], the hardening effect can be alleviated by decreasing the layer thickness, as shown in Figure 13. This tendency corresponds to the relationship between the layer thickness and the density of both irradiation-induced gas bubbles and defects.…”

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

See 4 more Smart Citations

Recent Studies on the Fabrication of Multilayer Films by Magnetron Sputtering and Their Irradiation Behaviors

Jin

Jian

et al. 2021

Coatings

View full text Add to dashboard Cite

Multilayer films with high-density layer interfaces have been studied widely because of the unique mechanical and functional properties. Magnetron sputtering is widely chosen to fabricate multilayer films because of the convenience in controlling the microstructure. Essentially, the properties of multilayer films are decided by the microstructure, which could be adjusted by manipulating the deposition parameters, such as deposition temperature, rate, bias, and target–substrate distance, during the sputter process. In this review, the influences of the deposition parameters on the microstructure evolution of the multilayer films have been summarized. Additionally, the impacts of individual layer thickness on the microstructure evolution as well as the irradiation behavior of various multilayer films have been discussed.

show abstract

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 85%

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

Section: The Effect Of Layer Thickness On the Irradiation Behaviors Of Multilayer Filmsmentioning

confidence: 99%

See 3 more Smart Citations

Recent Studies on the Fabrication of Multilayer Films by Magnetron Sputtering and Their Irradiation Behaviors

Jin

Jian

et al. 2021

Coatings

View full text Add to dashboard Cite

show abstract

Size-dependent microstructural evolution and mechanical properties of crystalline/amorphous high-entropy alloy nanostructured multilayers: Cu/FeCoCrNiBSi vs Ni/FeCoCrNiBSi

et al. 2023

View full text Add to dashboard Cite

Unique irradiation damage behavior and deformation mechanisms in crystalline/amorphous Ag/Cu-Zr nanolaminates

Li,

Zuo,

Wang

et al. 2024

Acta Materialia

View full text Add to dashboard Cite

Effect of He-irradiation fluence on the size-dependent hardening and deformation of nanostructured Mo/Zr multilayers

Cited by 31 publications

References 83 publications

Recent Studies on the Fabrication of Multilayer Films by Magnetron Sputtering and Their Irradiation Behaviors

Recent Studies on the Fabrication of Multilayer Films by Magnetron Sputtering and Their Irradiation Behaviors

Size-dependent microstructural evolution and mechanical properties of crystalline/amorphous high-entropy alloy nanostructured multilayers: Cu/FeCoCrNiBSi vs Ni/FeCoCrNiBSi

Unique irradiation damage behavior and deformation mechanisms in crystalline/amorphous Ag/Cu-Zr nanolaminates

Contact Info

Product

Resources

About